So the diaphragm isn¡¯t pressured when you insert the capsule into the hole
toggle quoted message
Show quoted text
On 8 Nov 2023, at 17:50, Casey via groups.io <mbuilders@...> wrote:
?Thanks! Why do the jigs always have smaller holes through the bottom? I could see it making sense in a blind hole situation so the part would slide in and out without air compression/rarefaction, but why in a jig like that?
On 11/8/23 05:42, Nick Roast wrote:
This is the jig and heatsink we use for soldering 10 mm capsules. The loose piece is held in place with elastic bands to keep the capsules steady and in good thermal contact with the sink. We have been using lead free solder for many years, its not as shiny and can often look like a dry joint, but it has been problem free.
