开云体育

Hi: I have not yet gotten to the point that I know the divisions can be set via SPI, but if they can I will allow for that. Art www.artofcnc.ca

Will check it out... Thanks, Art www.artofcnc.ca

I have been trying to get the g code to run in the macros as well and have not been successful. I think I am doing it wrong ;o) … Is there anyone having any luck getting it to work?? What I would

Actual code is without the paren's as in code "G0X6" This will execute a move to 6 in X, haven't tried G53 yet. Thanks, Art www.artofcnc.ca

Yup works fine on mine.. Save just the line code "g0 g53 x6" in a file called M60.m1s and call it from MDI with M60, the tool will move to Machine coord X 6. Thanks, Art www.artofcnc.ca

Thank you that works GREAT and the G53 works too

wrote: this distance to

Thanks John, Your method works perfect. code ("F100G1X1Y3") Todd wrote:

Hi, When I load my second or more g-code file, the extrema is incorrect, the only way I have found to correct it is to restart mach2. Regenerating the screen does not help. Any

Art and list-at-large: I am experiencing a slow down in performance at 35kHz (and incredible slow down at 45kHz) in Mach 2 as compared to 25kHz. Can someone tell me what is happening and how to remedy

Hi, The problem with the g28.1 is repeatable, Run your z axis to 2", type g28.1z1 in the mdi, manually trip your home switch, type g28.1 in the mdi, manually trip your home switch, this time it

One more quick question: Is there a way to pas a variable in to the Gcode? Example: M6START tool = GetSelectedTool() x = GetToolChangeStart( 0 ) y = GetToolChangeStart( 1 ) z =

oops, I meant for the second g28.1 to be another g28.1z1. Todd it

evening, i was wondering if mach1 / 2 is able to be interfaced to potentiometers for controlling feed rates and bounceless switches for controlling jog increments as well as axis selection. this

Hi,I have just got my plasma machine running,I am looking for some help on cutting ramp speeds Should i keep the ramp speed to the minimum the motors can handle so the require cut speed is acheived

Rutex don't seem to have made the RT990H chip datasheet available, even though it is refered to as the source of the SPI info. The RT990A chip datasheet has a full list of SPI register addresses

so I don't think any changes in acceleration or deceleration are needed for torch cutting. Just set your machine for the best performance. Slower ramps means the machine will run smoother (less

Hi Tom,Thank you,I will play around with the settings ,I plan to lift the torch between cuts but have the head floating,this will do for now as i learn more and the THC kit becomes available,when you

Just jumping into this thread because it very topical - can anyone recommend a msximum speed for my plasma cutting table - I'm in the midst of assembling the electronics and designing the table. By

wrote: at There are a lot of factors that determine cutting speed. For long straight lines perhaps the numbers from a table are appropriate but most of my cuts are complex shapes and lots of