开云体育

should Many thanks for original point and everyone's contributions to this. In light of them I have decided to strengthen the advice in the Mach2Mill manual to use a totally hardware EStop, limits

Did you every see a spark from a switch you turned off. Imagine if you switched power on and off over and over again. The switch would wear out. A problem for some motors is that their insulation

Steve, Linearity is only defined over the range 1kHz to 10khz, see note 5 in the spec sheet. For practical purposes it extends from about 200Hz to 12 - 13kHz, the bottom end depends on the filter

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the mach1mach2cnc group. File : /FtoV with Pre-scalar.jpg Uploaded by :

Hi Does anybody know of any software (e.g. keyboard remapper, mouse hot keys functions etc.) that will turn clicks on an IntelliMouse's scroll wheel into keystrokes? It potentially seems to be an

Here is the macro that I have made and it seems to work very well. What it will do is retract the spindle to Z-.1 (mach) You change the tool and move it where ever you like. Than it will rappid back

Fixed that - I had broken the screen wire on the connector! Another problem just cropped up, not used tooltables until now, lathe tooltable seems to overwrite mill tooltable & vice versa. Also can

One of the best remaper I have come across is AIMKeys http://www.aimsoft.com/product.htm Don't know if this will work as I don't have an intellimouse. John S.

Hi All I am trying to improve the macro section in the Manual and must share a bug in the manual and a feature in Mach2 with you. My "bug" is in the definition of the Param3() function in Appendix

Brian: Wow, string formatting within a macro.. Great Work!!! Art www.artofcnc.ca

That's it; I don't think I'm going to post from Yahoo anymore... How were the previous two for my first post... :-( I need to buy a new computer so I can run Mach1/2, and am looking

wrote: this. John, If it would help I think I have an electronic copy of a schematic for a strictly electromechanical (relays and switches) of providing a failsafe limit. Let me know if you want

How for enough programs.

Here are a few problems with toolchanges Lathe tooltable overwrites Mill tooltable Entries are listed as Z,X rather than X,Z? Using Jog screen to touch entries off always overwrites tool 0 even if a

Hi Steve: Thanks for the bugs. YOur right, I hadn't considered the poor tool tables or fixture table. I will implement new ones for lathe only. The touch off, should be done in your example by

Have a look at the graph "Tachometer linearity Vs R1" on page 6 With an input voltage of 12V, Frequency of 1000Hz and a R1 value of 350K it's 0.2% The input frequency is set by steps per unit and

Steve: Annoyingly no, I haven't found the problem yet. It may be that my version doesn't have it. I think I found the toggle bug, but I'm not sure yet. Almost all the other bugs are done..Still

Hi Art Welcome back I'm putting together a new system for my router. It's a Aopen motherboard with a 700mhz intel celeron running Win2K. I installed mach2 rc7 and manually installed the driver.