Hi All:
RC12 is online. It is being released a bit early because I didn't like that
MAcro bug being present.
1) DXF has selectable return position in abs or rel.
2) Rgen button is locked out during program run.
3) Errors go away after 5 seconds or so. The Error box was never really a
"current error", just the "last error", but it was confusing, so it now goes
away after 5 seconds or so.
4) THC reset Macro Command. THCReset() has been added to scripts and test
fix at M5 was removed.
5) In Turn , several changes. Macros of type .t1s are now present.
6) In Turn, no more automatic Safe_Z moves at present until they are ready.
7) Unknown Macro's will not hang the sytem. That was Less's problem, the M93
was locking up the script engine.
8) The Script engine tries to be non-reentrant. This means the parsing
errors and script errors should be gone. I can no longer repeat the parseing
errors.
9) Program repeat with auto decrement of the Z_Inhibit are now on the
corrections page. This should be set just prior to pressing Cycle/Run. It
will repeat a program, like a DXF conversion, xx times and each time
subtract the Z-Inhibit lowering varibale from the Z_inhib on each run. This
will allow for multi-pass from the DXF conversions. OR, if the Z-Inhib is
set to a higher value than your stock, it will run the program as a dry run
without actually lowering into the material.
Thanks,
Art
www.artofcnc.ca
