Art,
And of course that was the problem, thank you. Sometimes when the floodwaters are rising you forget to paddle ;
Frank Carpenter
toggle quoted message
Show quoted text
On Wed, 06 Aug 2003 07:51:59 -0300, Art <fenerty@...> wrote:
Hi Frank:
As a test lower the Z acceleration. This is the most common cause of this.
Rapid reversals of the Z is notorious for lost steps due to the huge inertia
of the Z axis. Usually it is the eaxis with the most torque required.
Thanks,
Art
www.artofcnc.ca
Yahoo! Groups Sponsor ADVERTISEMENT
To unsubscribe from this group, send an email to:
mach1mach2cnc-unsubscribe@...
Your use of Yahoo! Groups is subject to the Yahoo! Terms of Service.
