Re: Mach3 mill stopped in the middle of a job.
|
Mach3 notorious for not working well on a laptop, usually power savings features of a laptop cause issues ?
toggle quoted message
Show quoted text
From: [email protected] <[email protected]> On Behalf Of Chuck Kahler
Sent: Friday, January 12, 2024 12:14 PM
To: [email protected]
Subject: Re: [MachCNC] Mach3 mill stopped in the middle of a job.? Mike, That was my thought At first, then I remembered this little guy doesn’t have any limit switches on it. ? I’m wondering if something could’ve happened to the parallel port itself within the laptop computer.? I say this because I tried two different control boxes and it made no difference. ?
On Jan 12, 2024, at 10:36?AM, mike allen <animal@...> wrote:
? ??? ??? Limit switch & wires all good ? animal On 1/12/24 10:02 AM, Chuck Kahler wrote: I have a TAIG desktop Mill with a PMDX – 122 motion control board that utilizes a parallel port. The machine has always run without problem and in the middle of a 15 minute milling job it stopped about halfway and I cannot get the machine to respond no matter what I try. I even replaced the control box, which I had a spare, that ?included the?PMDX -122 motion control, and Gecko drivers, and that did not help.
anybody have any ideas what could’ve caused this?
|
