??? ??? Limit switch & wires all good ?
animal
On 1/12/24 10:02 AM, Chuck Kahler
wrote:
toggle quoted message
Show quoted text
I have a TAIG desktop Mill with a PMDX – 122 motion control board
that utilizes a parallel port.
?
The machine has always run without problem and in the middle
of a 15 minute milling job it stopped about halfway and I cannot
get the machine to respond no matter what I try.
?
I even replaced the control box, which I had a spare, that
?included the?PMDX
-122 motion control, and Gecko drivers, and that did not help.
anybody have any ideas what could’ve caused this?
?
Thanks,
Chuck
?
?
?
