开云体育

version 4.2-0.4612 making wooden stuff. the problem is not with making stuff it is jut the fact that the displayed jog increment shown when mach4 boots is not necessarily what it will move. it pretty mush always shows .01" which was the last used increment but it can move 1 inch instead. i have mentioned this a t least a few times.

I don't think so ... What Rev are you on and what are you doing?

______________________________

Brian Barker
Engineering / Development
ArtSoft | Newfangled Solutions
Livermore Falls, Maine (USA)
Phone: 207(618)1449
Webpage: 

On 12/7/2021 1:00 PM, spencer@... wrote:

was there ever a fix to the bug that causes the displayed jog increment to not necessarily be what it actually is when starting mach4? i am using very expensive router bits now and would be really pissed if i snapped one off because the jog increment showed .01" and it moved an inch instead. i try to remember to reset it each time i start mach4 but i am good at forgetting things and this could cost me $60 or more in one bad move. i jog to edges to set my home position for a piece.

there is a big difference between .01" and 1 " that would be about .99" certainly enough to break a new compression router bit.

Thanks Gary

-- 
Spencer Chase
67550 Bell Springs Rd.
Garberville , CA 95542 USPS mail only 
Laytonville, CA 9545 UPS/Fedex only

-- 
Spencer Chase
67550 Bell Springs Rd.
Garberville , CA 95542 USPS mail only 
Laytonville, CA 9545 UPS/Fedex only