From: [email protected] [mailto:[email protected]] On Behalf Of SCMWCAD1
Sent: August-25-21 3:41 PM
To: [email protected] Notification
Subject: [MachCNC] Joggin' my noggin'?
Hi Guys,
?
Long time since I¡¯ve been here. I¡¯m using my Mach 3 controlled mills after a couple of years hiatus. I¡¯m trying to remember how to move an axis by .001 when using a zero finder to the side of a piece of stock on the X or Y axis. I¡¯m able to run programs and move the table around using the direction buttons on the keyboard but cannot for the life in me remember how to get mach to allow me to move in incredibly small increments.
?
Anyone know what I¡¯m talking about and how to do it?
?
Thanks a ton,
?
Terry Wellman
?
Sent from for Windows
?
