I have these setup on my CNC router
Been awhile since I set them up but have a Ethernet smooth stepper driving a cn10 bob from cnc4pc. Then followed the bobs wiring instructions to set up. ?
toggle quoted message
Show quoted text
On Oct 28, 2019, at 9:38 PM, ronald_41 via Groups.Io <ronald_41@...> wrote:
?Anyone here have experience setting up Proximity Sensors with a Gecko G540?
I can't get mine to run properly.
The sensors have 3 wires: Brown V+, Blue V- and Black Sensing.
I have the Blue wires running to a Bus Terminal Block for both sensors and another running to the G540 V- of the Main Power Supply.
The Brown wires are both running to another Bus Terminal Block. The unit is powered by a 7.5V Wall Wart.
I have the Black Sensing wire of the X Axis Home sensor running to Pin 10 of the Gecko and the Y-Axis Black sensing wire is running to Pin 11 on the Gecko and they are all Active Low.
As long as my G540 is in E-Stop, Mach 3 registers their presence, yet when I unlock my E-Stop they cease to function.
Here is where I need some assistance.
