Art:
Thanks for info. I think the offsets are not being removed from X axis on M30. It resets to a value equal to original position + (or -) last coded position.
Tom
Hi Tom:
I don't know whats causing the slowdown, check to make sure the
pulse
width is not too high. If set to 0 or 1, the slowdown should not
occur, if
set too high, this may cause that type of problem at higher speeds.
>The incr. jog speed is at the current feedrate set.
I'll check out the X axis, you mean it doesn't reset in which way? to
zero?
or the offsets do not remove?
Thanks,
Art
www.artofcnc.ca
