开云体育

I was out last night on a fairly nice, clear night watching and imaging the planets and around 1am decided to hit the sack for a few hours so I could look at the sun come morning. Since it was clear

Hi Gabe, my first suggestion would be to remove the motor from the mount and test it with no load. If it’s still stalling then there definitely is something wrong. Could be the motor or, more

Hmm, this has happened a few times.? Have you rebooted a couple times?? Double check the battery with a DMM, and if that's good do an HGM reset and retest. Keep us.posted! -- Chip Louie Chief

Hello community, I recently took my Gemini Units to Losmandy for a hardware/software upgrades. On returning them to the mounts and turning on the power, I get an immediate and repeating RA Stall on

On Sat, Nov 30, 2024 at 01:41 PM, <rickdarden0899@...> wrote: > > I just purchased a used but like new AZ8. I owned a G11 from the Celestron > days so I am familiar with Losmandy products. >

I just purchased a used but like new AZ8. I owned a G11 from the Celestron days so I am familiar with Losmandy products. I have the typical stiction in the movement of the axes and the stuttering of

We don't do shame here, it's just complicated.? All these years later the latest Gemini firmware still offerers very sophisticated internal operations and user features. I don't know if anyone has

Thank you Chip Louie! That was it. Jeez! I'm just going to hang my head in shame! Thank you again.

Did you save the settings? -- Chip Louie Chief Daydreamer Imagination Hardware Astrospheric Forecast - South Pasadena, CA ( https://www.astrospheric.com/?Latitude=34.114268&Longitude=-118.1400894

I’ve been having a problem with the hand controller starting up in “Night Mode” when I turn the Gemini 2 unit on. The battery is new, I’ve reseated the SD card and reseated the screen. I can

Thanks, Paul!

Hi George, use the Gemini L4/5/6 tab and connect PEMPro to ?the ASCOM driver. Have Gemini turned on. PEMpro will get all the settings needed for your mount directly from Gemini.

Hi folks, Does anyone know which mount or mount settings to use for PEMPro for the G11T? That specific mount doesn't show up on the list. Do I just input the settings manually? George

Yes. ?I bias the load a small amount to the east and I see a clear difference on my G11T. ?Does not need to be much. ?Just a few lbs shifted to the east. JMD

I really like the new style Losmandy FHD tripod that I ordered with a Covid GM8G.? The Berlebach Planet wooden tripod I bought maybe 10 years ago has turned out to be fantastic after I installed the

Well, at least the bar has enough meat on it to be milled to the Vixen profile.

Hi Mike, The debug log does not indicate the underlying cause, but there was a lapse in communication with the Gemini driver from about 20:38:08 to 22:12:00, resulting in some empty mount values.

Thanks, that profile will work.

By the way, 10 seconds of Googling brought up an archived profile:

Greg, First, if it was me, I'd follow Chip's advice: Buy it. But if you must make it, then it isn't just the dovetail plate your interested in, it's the radius blocks. As to them, the radius and the