Hi Mike,
The debug log does not indicate the underlying cause, but there was a lapse in communication with the Gemini driver from about 20:38:08 to 22:12:00, resulting in some empty mount values. I'll put in a check for communication problems like this in the next build.
I also noticed that the selected star was saturated at 32,767.00 (the brightest pixel in the star) throughout the four logs. This indicates the star was saturated which can produce inaccurate star centroid locations. To fix this you should set the Max Star Brightness to 15,000 on PEMPro's setup tab.
-Ray
toggle quoted message
Show quoted text
-----Original Message-----
From: [email protected] [mailto:[email protected]] On Behalf Of Mike
Sent: Saturday, November 23, 2024 7:02 AM
To: [email protected]
Subject: Re: [Losmandy_users_io] Problem with PEMPro not drawing in all needed G11G (Gemini 2) Mount &
Camera info for valid PE review and analysis
Hi Ray, thank you for getting back to me. I have attached a zip of 5 files, 4 are the log file data runs for Nov. 13th,
the 5th is the debug file for those runs.
Run 1 - File 210114 (Full 30 min, Log is missing needed info to properly analyze)
Run 2 - File 214144 (Ended after 23 min. due to approaching Meridian, Log is missing needed info to properly
analyze)
Repositioned scope using hand controller between Runs 2 and 3 to a part of the sky where I normally image, I
believe I ran the calibration wizard again)
Runs 3 and 4 - Files 221509 and 225519 (Both ran full 30 min., both have all needed log info and run fine in
Analysis and Log Viewer)
Also, if you can answer, what is the data element (Stepper Location) I described above and why would that also
be missing from those problem runs, seems to indicate that no information was communicated from Gemini or the
mount at all during those runs.
Thank you again for any help
