开云体育

Thanks for all the responses.? ?The universal opinion is that 3mm wiggle is not an issue for general tracking.? ?But how about tolerance to wind?? ?I have been trying to use my 127mm refractor

Hi Bret Wayback is correct the mount needs to be connected before these are populated, but this may be a moot point for you: Use the latest PEMPro 3.0.0.46 and it will automatically set it to 2x cycle

Hi WayBack, Thanks for the suggestion. I retried and made sure I connected before going to the configure PEC window … no luck … the PEC selection box is?still blank. ?I also tried uninstalling

Hi Bret, What version of Gemini.NET driver are you using? Might be worth a try to update to the latest test version (1.1.10) to see if that makes a difference: https://gemini-2.com/ASCOM.html It looks

Probably not this but: If I open Gemini Telescope -> open subpage Configure PEC -> connect mount.? ?Then it behaves as you describe. If I open Gemini Telescope -> connect mount -> open subpage

Sounds like you’re volunteering, Michael ;)

I do not know, but it is certainly a solvable problem. May be the problem is with the ASCOM platform? The dialog is just what you shows, but no clue why the pulldown box is empty. I don't know if this

It's just too bad that no one will try a TeamViewer abusive the problem real time...instead of a dozen emails. [email protected]> wrote:

On Fri, Aug 26, 2022 at 04:02 PM, Jim Magill wrote: > > How much wiggle or movement should there be for the RA axis if the > spring-loaded worm and secondary screw are adjusted correctly?? ?I >

Hi Daniel, Thanks for the quick response! ?I believe I am doing exactly what you describe ... best as I can tell, I'm connected to mount and everything looks correct except that when I go

Interesting, operationally the 3mm movement does not exist.? Push on the DEC shaft let go and it will return to the starting point because the force creates movement by pushing against the worm

indicated the turning direction of the RA drive. it's the direction of the guidepulse, but RA axis never stops or reverses -- Brian Brian Valente astro portfolio

I'm attaching last night log.? I'm not sure if this is the best I can post, because I used dithering and this makes analysis more difficult.? I'm aware of the machanical causes of all the main

Load the Gemini 2 driver,? click to show the hand controller window, connect to the gemini 2 and then, setup->configure pec? which, after some time, will brought to you the PEC configuration dialog

Hi Folks, I'm new to the G11/Gemini, but not to astrophotography and I have used PemPro previously with great success. ? I'm using Brian's fabulous instructions here:

Thanks for the clarification. I really thought that the direction of the arrows you see in PHD2 indicated the turning direction of the RA drive. Best wishes, Daniel

That’s about right. There has to be som movement I remember this has been discussed lots before. ?3mm at the end of the shaft is a lot less at the gear -- Brendan

Backlash in Ra is not a thing! My focus would be on Dec. You need an FFT on Ra to understand it's behaviour. Peter

Michael has it correct, you are likely seeing the effects of the spring-loaded worm. It's not a good idea to try to zero it out, that's not how the spring-loaded worms work Roland Christen from AP did

Because it's spring-loaded, you'll see a lot of wiggle if you push moderately hard, but that doesn't mean you have that much backlash during normal tracking.