开云体育

That sounds?exactly like?what I’m seeing! ?I’ll have to try the ethernet connection … thanks for pointer!

The PEC options didn't appear for me when I was connected via USB, but did when I connected using Ethernet; see this thread (

Ok. I’ll?ignore for now.

PEMPro will overwrite what you already have, so that is probably moot as well but it generally sounds like symptoms of not being connected. [email protected]> wrote:

Thanks, Brian. ?Perhaps all of this is a moot point/issue then? ?Assuming??PemPro is taking care of 2X PEC for me, a couple of oddities still remain (note I did use the?latest PemPro last night

Hi Paul, I was using v1.0.84. ?I just?installed v1.1.10 and tried again … no difference.? As for a previous PEC, yes as a matter fact … I made a first attempt of using PemPro last night and

Thanks for all the responses.? ?The universal opinion is that 3mm wiggle is not an issue for general tracking.? ?But how about tolerance to wind?? ?I have been trying to use my 127mm refractor

Hi Bret Wayback is correct the mount needs to be connected before these are populated, but this may be a moot point for you: Use the latest PEMPro 3.0.0.46 and it will automatically set it to 2x cycle

Hi WayBack, Thanks for the suggestion. I retried and made sure I connected before going to the configure PEC window … no luck … the PEC selection box is?still blank. ?I also tried uninstalling

Hi Bret, What version of Gemini.NET driver are you using? Might be worth a try to update to the latest test version (1.1.10) to see if that makes a difference: https://gemini-2.com/ASCOM.html It looks

Probably not this but: If I open Gemini Telescope -> open subpage Configure PEC -> connect mount.? ?Then it behaves as you describe. If I open Gemini Telescope -> connect mount -> open subpage

Sounds like you’re volunteering, Michael ;)

I do not know, but it is certainly a solvable problem. May be the problem is with the ASCOM platform? The dialog is just what you shows, but no clue why the pulldown box is empty. I don't know if this

It's just too bad that no one will try a TeamViewer abusive the problem real time...instead of a dozen emails. [email protected]> wrote:

On Fri, Aug 26, 2022 at 04:02 PM, Jim Magill wrote: > > How much wiggle or movement should there be for the RA axis if the > spring-loaded worm and secondary screw are adjusted correctly?? ?I >

Hi Daniel, Thanks for the quick response! ?I believe I am doing exactly what you describe ... best as I can tell, I'm connected to mount and everything looks correct except that when I go

Interesting, operationally the 3mm movement does not exist.? Push on the DEC shaft let go and it will return to the starting point because the force creates movement by pushing against the worm

indicated the turning direction of the RA drive. it's the direction of the guidepulse, but RA axis never stops or reverses -- Brian Brian Valente astro portfolio

I'm attaching last night log.? I'm not sure if this is the best I can post, because I used dithering and this makes analysis more difficult.? I'm aware of the machanical causes of all the main

Load the Gemini 2 driver,? click to show the hand controller window, connect to the gemini 2 and then, setup->configure pec? which, after some time, will brought to you the PEC configuration dialog