开云体育

I re-read that you already have the brass worms in hand. Curious what a measurement with those in would look like. I'm curious how much improvement others have seen as they transition from steel worms

Bryn, Nice work. This is not a simple process to navigate but I think you are doing fine. Toward the bottom of Michael Herman's instructions he goes into how to interpret your recorded guide logs. I

So, I have had my first attempt at trying to get a baseline. I followed the guidance above and produced the logs in the attached file over about 50 mins on a GM 8, with Zenithstar 61 at 360mm focal

This could be either the 160 pr 200 extension? thanks jim

I think I see now. The 200 is a pier extender, and the - 1/2” bolt goes through the extender bottom and MAL MA adapter, and a 3/8” bolt goes through the top of the extender into the ZWO Could I

Thanks, I am a bit confused (does not take much ?). I thought the MAL to MA adapter would attach directly to the Losmandy HD, and I would have a bolt come up from underneath that to attach to the

Also check out the ADM "MyT Tripod Adaptor" for the G11 ( https://www.admaccessories.com/product/myt-tripod-adapter/ ). It has a square plate on top designed for the Paramount MyT, but works

Also suggest you get the ZWO pier extension as your scope will swing in much closer than a Losmandy at the bottom with the AM5 being a much smaller

I did just that. Works perfectly with no wiggle, very solid. The center hole in the adapter accepts a 1/2” bolt. ?I drilled out the center hole in the base plate of the ZWO 200 pier (was almost

*Could someone please tell me the center hole size for the MAL to MA Adapter? * *I wish to attach a ZWO AM5 to me HD tripod.* *thanks,* *Jim*

Appreciate the help and will try NINA Discord. I have tried the Restore Guiding and although it was not selected, it did not help. System ran great for 2 years but now after a Meridian Flip, the

That would be worth a try. ?I have longer vids too and want others to see them on the hope someone can assist with the drift in the tracking. ?On the one minute video the station just starts to

Depending on how you feel about Google, posting a high-res video on Youtube might be the easiest thing to do. Then share a link here.

Anyone have any advice on video file editing or compression? ?I have several vids but I can’t post them do to size. ?My smallest is 85mb and is only 2 sec. ?Some type of compression needed?

I have been doing a lot of this stuff before I found the page I wish that I had found it sooner! Look at the balance, clutch washer assembly order and orthogonal alignment tips and follow his

On Thu, Sep 12, 2024 at 06:34 AM, Dnorton wrote: > > At the risk of sounding like an idiot, I hate to ask a question that may > have already been asked... I recently bought the G11 with Gemini 2

If you didn't buy the mount and Gemini 2 new from Losmandy you should verify the firmware versions. Go into the HC - Hand Controller - sub menu then select the "Info" screen and you will see the HC

Thank you for the information, that really helps. Now I know to keep those settings on. I will check every time I turn the mount on. And yes, my mount is the new L6 and the chips have the updates.

Yes, have the 4x encoder settings turned on with L6. There's no reason not to, and a few good reasons why it might help.

The difference is that the software can now detect the position of the motors with 4x the resolution that it could with the old firmware (assuming that the servos IC’s firmware has been updated).