开云体育

I’d probably just give Losmandy a call. For parts like that, I’m pretty sure they would be anble to get them even if they aren’t listed on the website. JMHO Jim -- *Visual Telescopes* : Meade

Hi, I went to adjust the OPW backlash adjustment on my GM811 DEC and noticed one of the spur gears' set screws was completely loose. When I went to tighten it, the spur gear fell and hit the brick

Mine works perfectly.. Guiding was 0.6rms for years with no adjustment of my old 2 worm block model.. Derek _____ Sent: Friday, March 15, 2024 7:09 PM To: [email protected] Subject:

I have imaged and tested at several different focal lengths on my 20 year old but fully updated G11G and have seen the mounts tracking improved not.in absolute err

I've been using an ES 127mm Refractor for a couple years on the G11G. Absolutely no problem at all. I started using it on the G811G and that handled fine as well. You are good to go with a 130mm if

Oh here is a picture of my NUC and the dovetail, I think it might be clearer ...

I have been imaging for a few years on my G11G with my 150mm refractor @1050mm, with a total weight of 24Kg on the mount. I believe it is very close to the mounts limits, but doable. I could achieve

I should add, I sold the C8 and replaced it with a SkyWatcher Esprit 120. Wonderful views, and being side-by-side with the RASA is lots of fun. Matt wrote:

Until recently, I was running a C8 and RASA 8 side-by-side on the G11G. My total RMS was rarely over 0.2. If your guiding is a going well and then you get a blip, I’d reach out to Losmandy. My mount

I get great guiding with my AT130, anything more the .5 RMS is a bad day. What voltage do you run you mount at? It sounds like you might be having a cable snag.? I do run a .8 reducer on my

I'm curious if anyone here is getting good imaging results with a 130mm refrcator on their G11G? I've been trying with my C11 at f/7, which is double the focal length of most 130s so much harder, but

The air will connect via USB to the Gemini 2 You will then connect to the air via a phone or tablet over wifi.? It's pretty easy.? I use an iPad to control the AsiAir Plus, which runs my camera ,

I have an ASIAIR plus and it works really well with losmandy. Just hook it up . I connected to the ASIAIR with my laptop or phone. Whatever you use phone, iPad, laptop you just go into setup and

I had always been curious about the rather random motor sounds I get while doing Gop Tos. An oscillating sound would get my attention frequently. I figured out that it is only when both motors are

Mark, The instructions will be unchanged for level 6. I have not used ASIAIR but I assume you just select the Losmandy mount. Paul

Mark, While, I’m not Paul. I have found this site useful and this article a good help: ZWO ASIAIR Ultimate Guide highpointscientific.com There are also a number of great Youtube videos done by Brian

Chip, thanks so much for the detailed advice.? Replacing the battery didn't help. I am getting a red startup screen which states to update the firmware. I decided to send in th Gemini 2 and hand

Thanks Paul, are you aware of a guide (or thread on this community) to setup the ASIAIR with Gemini 2with the new level 6 upgrade? thanks Mark

Tim and All, I am a Mac/iPad user. Once I get the Gemini 2 Level 6 factory upgrade back from Losmandy, will I need anything else to use the ASIAIR Plus via USB? I have been using the ASIAIR with a ZWO

Mark, You will need to set it up again but apart from that the software will not see any difference. Paul