开云体育

Peter that's a spectcular image, thanks for sharing!? 30 hours integration, a lot of work but it really paid off.? No better way to conclude a discussion than obtaining results like these.? Well

The manual <https://diffractionlimited.com/wp-content/uploads/2016/09/st-i_manual_1_1.pdf> says: GUIDE PORT: This is where you connect the supplied 6 conductor modular phone style cable to the

Hello all, I need to repair/replace the RA gearbox on my G11 with OPWB and Maxxon motors. Looking up instructions, I can see that this is relatively simple for standard worm/block with worm gear

I'd love to see the logs, but ASIAIR requires internet access since the only way to get at the logs is to email them. If you're imaging in the field using the internal ASIAIR wifi, you're out of luck.

The iconic bubble nebula is 7 light-years across and 7,100 light-years from Earth in the constellation Cassiopeia. I've tried to capture the percussion effect in this image, in the waves of radiating

If the issue was successful plate solving but the centering routine never quite made it after successive attempts, then yes this would be something to look at My understanding from the OP was that it

This link on the Facebook ASIAIR page explains the issues. Basically, change mount setting to Jnow. https://www.facebook.com/groups/ASIAIR/permalink/1864925700337311/

I had something similar with the original version. It turned out it was a difference between Jnow and J2000 settings between the mount and the ASI Air. Off the top of my head, both should be set to

I must be missing the story then? :) That doesn't really say anything other than the mount and asiair were in agreement to within 1 arcsecond of the slew and app. That is probably a pixel or two (not

Hi Brian, The image attached tells the story. ASIAIR's auto-centering fails to plate-solve and never centers the object in the FOV. Notice the coordinate mismatch. It's just 1 arc-second difference,

Thanks Mike and I apologize for not getting back too you sooner. ?I have tried it both ways Serial from STi to the G2 and USB B port cable and neither seem to lock the guide scope to the mount as

Hi Paul, First off thank you for reply incase I did not notice it. I am back at trying to the Sti to guide the Losmandy G11/g2 as it once i click on the star noting happens and quickly the star is

If your back off screw doesn't seem to be working it could be that the bottom cap screws are just a bit too snug to let the OPW move. If they are just a little bit too snug they lock the OPW into

Daniel - please use the support ticket you have open and send a video Thanks Brian -- Brian Brian Valente astro portfolio https://www.brianvalentephotography.com/astrophotography/ portfolio

If I unscrew the back-off screw I should see that the gears offer great resistance as a consequence of the worm getting pushed to the gear, right?? Well, this is not the case. If I unscrew the

Daniel How are you measuring this effect? It's impossible for the backoff screw to have no effect if you have the spring tension set correctly - or at least I've never encountered a situation where

Hi Brian, Thank you for your answer. I have tried to adjust the DEC SLW starting with resetting the spring length to about 8.4mm . What I have found is that the secondary, i.e. back-off screw, does

Hi, Jamie Is this new version included in the latest ASIAIR firmware update? ever since I updated my ASIAIR Plus firmware, GOTOs and auto-centering are consistently failing for me with my GM811G

Glenn I haven't had any issues with the Pro and latest firmware That's not much detail to go on - do you have anything more specific regarding the errors? -- Brian Brian Valente astro portfolio

Ever since I updated the firmware on my ASIAIR Plus to the latest version, I keep getting pointing errors and auto-centering failures on my GOTOs. Is there anyone else experiencing similar problems