Re: Losmandy presentation: achieving <1" performance, July 22 2PM PDT
|
Hi Jim
thanks for the note - those parts look pretty interesting, for sure
I like the "T" style handle
On Wed, Jul 22, 2020 at 4:21 PM Jim Waters < jimwaters@...> wrote: [Edited Message Follows]
Brian - Good video.? Thanks
FYI - I use these for locking my RA on my GM811G.? All parts are from Ace Hardware.? I think the total cost is around $19.
2x each
- Plastic handle
- 3/8 - 16 stud (I think its 2" long)
- 3/8 washer (To increase contact surface area and protect the rubber washer)
- Hard rubber washer (For compression tightening of RA)?
- 3/8 washer (To increase contact surface area and protect the rubber washer)
- Fiber washer (To protect the mount finish)
EDIT - I used epoxy to secure the 3/8" studs into the plastic handle.? You can also use?Loctite Threadlocker Red 271.
-- Brian?
Brian Valente portfolio
|
