On Sun, Feb 9, 2020 at 4:30 PM Sonny Edmonds <sonnyedmonds@...> wrote:
I spent today finishing up my harnessing, and consolidating my wiring. I have two wires leaving my new GM811GHD. 12 volt power, and a single USB from my HUB. But lets see if I can get some pictures up....
?I use a product called to build my harnesses.
?
?Here is where the Gemini wiring breaks out of the harness. Ball bungee for support of the drop wires.
?Left to my own devices, I get creative. I had a pair of , and the Gemini 2 controller fits beautifully where the leg extends. Go back to image 1 and you'll see it there. I put the "loop side" on the HC so it is gentle on the hand. The "hook side" on the leg. If you try this, I put the sides together, then mount the pair to one device, then peal the other side and placed the HC against the leg. Done. I pull the dots apart and hand press them snugly to the anchor point. Finally, I support the drop wires with a from the Gemini 2 T-bolt. It gives some flex if needed. 4 wires disconnect the telescope from the mount. The RA and Dec cords disconnect the head, plus a harness snap strain relief. And 3 wires disconnect the Gemini 2. Typically for me I bring in the telescope, then the head, and the tripod. The harness and my computer together. -- SonnyE
