¿ªÔÆÌåÓý

  1. Losmandy_users
  2. Messages
Single Messages Topics Expanded Polls

Re: Loading Pempro PE Curve to GM811

 

¿ªÔÆÌåÓý

Ah thank you guys for the help! I'll check the gemini controller to make sure that wasn't sending an incorrect value. I was able to push once I manually changed inside Pempro, but I'm going to check if this is why it had ended up 215 after using the Mount wizard. Thanks again!

Ross

From: [email protected] <[email protected]> on behalf of Brian Valente <bvalente@...>
Sent: Sunday, January 12, 2020 6:32 PM
To: [email protected] <[email protected]>
Subject: Re: [Losmandy_users_io] Loading Pempro PE Curve to GM811
?
>>> ?and that the mount type is set correctly in the Gemini controller.

Ross - doublecheck this part in your gemini controller



On Sun, Jan 12, 2020 at 1:06 PM Ray Gralak <groups3@...> wrote:
Hi Brian and Ross,

PEMPro gets the worm period by interrogating the Gemini controller, so make sure you have the latest firmware installed and that the mount type is set correctly in the Gemini controller.

-Ray Gralak
Author of APCC (Astro-Physics Command Center):
Author of PEMPro V3:?
Author of Astro-Physics V2 ASCOM Driver:

> -----Original Message-----
> From: [email protected] [mailto:[email protected]] On Behalf Of Brian Valente
> Sent: Saturday, January 11, 2020 8:15 PM
> To: [email protected]
> Subject: Re: [Losmandy_users_io] Loading Pempro PE Curve to GM811
>
> That doesn't sound right - the default worm period for gemini 4/5 is 239 on my setup. I'm a little concerned that
> something else may not be set up correctly, even if you did adjust the worm period.
>
> you should be able to get the correct worm period setting up via the mount wizard. If not, you might want to
> ping Ray over ta the PEMPro user forum
>
>
> Brian
>






--
Brian?



Brian Valente
portfolio

Join [email protected] to automatically receive all group messages.