Thanks..
But I can¡¯t do that as the guidescope is mounted and aligned.. There is
NO WAY I am removing one of these screws now.. I had expected to find the right
PDF from Losmandy ¨C they are very good at having all patterns somewhere ¨C
but haven¡¯t.. I did find some Vixen rails with 5/16 ¨C 16 holes in
them.. 99% sure that¡¯s the guidescope adjustment screw size also, so I *will*
go buy some from ACE..
And
some drill bits.. Some painter¡¯s tape.. etc..
?
No
idea how to countersink a hole so the bottom is flat and not conical so the
bottom of the cap screw has a place to land, but that might become apparent
when I am standing in the store eyeballing the drill bit section..
No.
But if you take one to a Lowe's, or a Home Depot, they usually have a thread
matching card or device and you can >carefully< try your screw and find
the right thread and pitch.
Ask for help if you need to, but remember, the help you get may know less than
you do and might screw up your screw.
And that you don't wanna do.
