开云体育

A new Firmware v1.08.01 is now available at https://lab599.com/downloads/ ( https://lab599.com/downloads/?fbclid=IwAR1w1-80_FxoaUCZxBrXiphNvD1VFsnZG6Wv_gJw793bn4iOE8STtjK0fvs ) Added CW Beacon mode

I think that it was an older version of Linux that didn't have some of the dependencies for that package. Eventually I just used windows. I do think it was 64 bit, a Toshiba portege that is running

This $8 soundcard is the way to go if you're looking for easy.... https://www.amazon.com/dp/B00IRVQ0F8/ref=cm_sw_r_cp_apa_glt_fabc_BYWVT2WRQRHC7325RRGD?_encoding=UTF8&psc=1

Additional question to the the wiring diagram: Today the PCs/Laptops normally have an USB Port for sound; is there a possibility to change the wiring diagram in the way to use an USB Plug instead of

Use a fine tip iron and solder.? watch lots of you tube instructional videos on how to solder, plan on ruining a couple of cable ends. Tin the terminal and wire ends. You learn by doing! Wish i could

I soldered the grounds from the cables together first (before the ground lead) and then applied a bit of solder to the ground of the cable.? Then I rested the ground on the lead, then applied the

Any advice for soldering the audio data cable.? I do not have much experience with soldering trying to figure out a way to get at that center pin for the ground.? I have a Hakko iron with some

Yes I was able to update using linux.? I downloaded changed it to executable and just ran it from a terminal window.? A window popped up and I ran the update.? You have a 64bit processor?? I think

Thanks John, Thanks for the phone call regarding this. This radio offers so much more in terms of ruggedness that it is ideal for what it is designed for -field use. I have been through several

They can do the modification. They are working out a procedure so I can perform it here. They said they would let me know once they had it ready. > John N7ROJ Lab599 US Service

I am seriously considering one of these machines. ?My big concern is the ability to operate outside of the amateur bands, specifically MARS and SHARES frequencies, as that is my primary usage. I have

Search Amazon for: GRIFITI Chiton Slim 10 5 x 10 inch Keyboard Sleeve . This pouch fits the rig like a glove as if it was designed for it.

Nice, however the Amazon link does not mention the pouch.

this is a 1uF cap - is this correct ?

i don't suppose there is a cheaper way to get 1 capacitor ? seems silly to buy 1 and pay $1 for the cap and $8 shipping...

Marc, Nice case, good fit. I am using a Skynew Powerbank Hard Travel Case that another TX500 user found on Amazon, https://www.amazon.com/Compatible-20000mAh-26800mAh-PowerCore-SKYNEW/dp/B07FSKQDR9 .

Hey all, I'm a bit of a keyboard nerd and it just occurred to me that the pouch I have for my planck keyboard is just about the perfect size for the TX-500. Those pouches are sturdy, they have a

Thanks Michael, I don't know how I missed it. Bob WB6AGE

Hi Bob, RE external amplifier control, page 29 of the manual says: You must connect pin 2, (PTT OUT), open collector of the REM/DATA connector to the PTT control relay of the external power amplifier.

Hi Glenn, Curious if the amp keying signal on pin 2 is documented anywhere.? Do you know if it's a relay output or transistor switched? Thanks in advance, Bob WB6AGE