开云体育

https://downloads.lab599.com/TX500/Lab599-TX500-adapters-wiring-diagram.pdf

A friend of mine not in this group asked Lab599 via email for some information. He never got a response from them. if you are directly familiar with exact knowledge please respond as I have no desire

Thanks Dominic, Much appreciated. 73 Mike VK6MB

Nope. My ftdx-10 goes super fast. It has a second vfo ring for this which is very convenient as the slower knob doesn't automatically speed up exactly then when you don't need that feature.

Menu 23 has the tone power level added there.

Absolutely, this was much needed and behaves more like my IC-7300. A feature Yaesu owners dream of (I have a few Yaesu rigs and you need the [fast] key to spin up fast. Great feature.

It is now more like the Icom IC-7300 where spinning the VFO it rolls quicker than before in Intel mode. Based on the assumption that if your spinning the VFO fast you want to tune quickly. Spinning it

You need to find tone in menus and lower there

* Mike <beally@...> [2023-08-02 09:42]: The setting is a submenu of menu `23 Tone`. -- They must often change, who would be constant in happiness or wisdom. — Confucius

Is there information on lowering the tone power? I have just updated the firmware, and even though I turn the xmit power down to 10%, the output on tone is still around 5W TIA, Mike VK6MB

Hi Ronan, Thanks for your feedback, very helpful! Good news: After I reset the TRX some more times and copied the settings and memory channels back, the issue is much less severe. If you turn the VFO

The update went well, I can lower the Tone power to 10% for use with the DIY599 amp ?. Now, if I could lower output power to 100 - 500 milliwatts for JS8Call . ?. . ?

I've just tried the new firmware on my radio and the VFO encoder works normally. They've adjusted the scaling so it's easier to move quickly across the band .

Mine is about the same age. Certainly pre-invasion anyway. I'll try the firmware on it and see how it goes.

For comparison, the Harbor Freight Apache case 2800 is about the same size and is $30, vs. $70 (w/shipping) for the Windcamp. You would have to pick out the foam to fit though. 73, Mark, K5MGJ

After loading the firmware, some VFO modes and/or frequencies were different. So I tried to reset the settings but unfortunately, the strange behavior with the '00 Encoder: INTEL' setting is still the

This was a problem with one of the earlier beta tests but was fixed, or apparently not. If the problem persists please email with explanation to support@... 73

I just updated my firmware and it works properly.

Sry, misunderstanding.... I have only straight GX-12, in case TimAF6TF needs only a female I am sure I can help him out. Matt/K0MOS

Thanks for the info Bill. I wonder if the Lab599 case is a little bigger. It has a pocket that could probably hold a lighter end-fed or dipole. I have a Pelican case but it's quite a bit bigger. I