开云体育

Jim, Great advice and information! ?I was able to register yesterday and confirmed w a test message. ?A very helpful service. ?Thank you very much. ?Heading out soon from my QTH. Hope to talk w

Humm....no files section?? Or am I not permitted to post a file??? -- 73, Jim / AC3B https://www.qrz.com/db/AC3B

Hi Mike....wonderful news and I would be very surprised if you don't quickly get addicted....it is really great to be outdoors and operating. For spots, I recommend to have a backup plan if internet

Good luck Mike. Looking forward hearing about the experience. Unfortunately I won’t be able to participate.

Hi All, I'll be attempting SOTA for the first time this Saturday with my new Lab599 TX-500 Russian QRP rig. I'll be using the SOTABeams Tactical mini mast with a linked dipole. ?This setup has worked

Dave, That may have been my picture in an earlier message. I have not found time to actually use that cable, so not sure what the internal make-up looks like. I found some RG174 in a box and had

Hello - I noticed the posting regarding use of cables from a TRRS (3.5mm 3-circuit) to RCA adapter as pictured. I have spent some time using this connector type and adapters as shown as short RF

Any word on when the next TX-500s will ship to the U.S.? Ham Radio Outlet is already sold out. Tony -K2MO

David, Great to know they have made another shipment. The Hand Speaker-Mic jack is only for an external speaker. I expect it may only be useful for a single channel speaker or only one channel of a

Hi, Just received my TX-500 last week. Found a connection problem on the headset jack on the microphone.? ?Seems only right channel was being connected.? Nothing on left channel.? Need to

Yep, a good choice. Doug

Thanks for the replies!? I'm trying to cram the capacitor inside the connector, to keep a clean look and protect the connection.? Would this capacitor work instead?

Well, I have not looked at the 599 connectors, but the capacitor will go in series with the signal lead. It can be placed anywhere in series. At either connector end, or somewhere along the cable,

Again, I'm new at fiddling with electronics.? Two more questions... To install it, do you need to snip the audio cable and solder each end to the capacitor, or just cut away enough shielding to

If I were looking for a 10uF cap, I would choose a non-polarized ceramic one, such as this https://www.mouser.com/ProductDetail/TDK/FG20X7S1H106KRT06/?qs=qf2ddTMq67WcrUW7BHxGTg%3D%3D And yes, when

New to Ham radio and working/soldering components in general.? I'm looking up 10uf capacitors and getting dizzied by the different types.? I'm assuming (and I know what the first 3 letters of that

Yes, that's what I had to do.? v1.05.00 did not enable the USA 60 meter band.? I went back and installed v1.04.07 and that allowed 60 meter ops. This is what I was instructed to to in an email from

There’s a new eham review....from Feb 10.... https://www.eham.net/reviews/view-product?id=14781 -- 73, Jim / AC3B https://www.qrz.com/db/AC3B

Thanks for the post. I had to fiddle for a while too to get it working. In my case the cables were just fine, the issue was a older version of the Prolific driver which only worked after several

I am encountering the same issue. It just wants to modify, repair, remove.