开云体育

Larry, Are these the chips you used? James KK4WXA https://www.utmel.com/productdetail/nxpusainc-tda7056atn2518-4771301

This does make me wonder if the issue is frequency dependent? Right before this happened I ran the radio on 40 and 20 meters with no problem. It was when I went 17 meters that the issue occurred. I

VE3EGA, you mentioned that “ HF Manpacks are 'very much' mainstay comms in All Theatres,” but as far as I can tell, 99.99% of us rank-and-file hams aren’t marching through warfare “theatres”

SO20 case, 1.27mm leads spacing. It's huge, actually )))

Dear all, due to lack of time I want to sell my *TX500* and my *PA500* , both are in a very good condition and have not been used much (hence the reason to sell it ;-) ) They both come with a

I took a before picture but not an after picture. It wasn’t an easy job but if one is careful it can be done as seen in photos. If I didn’t like the radio so much, this issue would be a deal

Even Elecraft have jumped on this wagon: https://elecraft.com/products/kh1-f EVEN Elecraft jumped on the wagon? For Ham Radio, Elecraft largely built the wagon! It started with the KX1 that came out

In fact the use of HF has a renewed focus for beyond line-of-sight communications as this paper from L3Harris explains:

Bob, HF Manpacks are 'very much' mainstay comms in All Theatres, using different networks: Harris, Racal, Thales, Codan, Barrett and several others have multifrequency product offerings. I am all for

Here's a few pictures of my repair a few weeks ago.? Larry probably did a better soldering job than I did... those pins are so small... - Trevor, N6TJL

Larry did you take any photos of your heroic repair ? Thank you, Greg K7YOM ????? ??Sent from my iPhone.......?

The top surface of the chip rests directly on the aluminum case, and there is thermal paste between the two because the case is in essence a heatsink.? So I do not believe a socket is possible -

Even more concerning is the fact that this chip is now obsolete and the few places that may still have it are running down their stocks. From what I have read there’s no direct replacement for it.

Would it be possible to install a socket to make future repairs easier/faster? ?I haven’t opened mine up so I don’t know if there would be room for a socket to go on the board in addition to the

I have used my radio for many activations for both POTA and SOTA with never a problem. What ?happened today was extreme and totally different from my prior setups. I have used a 9 foot tall center

Man I have to say this is a little bit concerning. Super light weight field setups tend to have antenna, feed point and the radio quite close to each other. In addition to that the antenna system is

Thanks so much for sharing all this Larry!! ?It is greatly appreciated!

I am not sure a choke would have helped in this case. I was using two- 3 foot long cables, one going to the tuner and the other going to the antenna. Everything was way too close together, stupid

Larry, What chip did you order and where did you get them? Did you do the repair yourself? Thank you, Fred/N7PN

Thanks for the cautionary tale Larry. Do you think adding a choke may have prevented the issue? James KK4WXA