开云体育

Glad u got it. Bob. W4JFA

Kenwood support provided a fix: reset the VFO. Wiped out any stored frequencies but they also provided a primer to restore them. Now the VFO scans the way you described. Probably a moot exercise at

Good suggestion but no joy. Held it down for 15 seconds. Still no scan.

Did u get it figured out? Mine scans in VFO mode and holding the VFO button down until scan begins. Try holding the button down longer. Just a thought. Bob. W4JFA

I'm Richard, KE5JKJ, and new to the group.? I can't get my TH-F6A to scan at all.? Instructions are clear: VFO, BAND, VFO (1 S).? VFO just beeps once but no scan.

Thanks. Too bad I didn't notice the typo. Oh well. 73

Your post made it to the group Donald KX8K ---------------------------------------------------- Some ham radio groups you may be interested in: /g/ICOM

Good morning, I'm new to the group so checking to make sure I have my settings correct. 73 from North Carolina. Bob W4JFA

Selling is allowed in this group for ham radio equipment only, and at least one of the items for sale must be related to the purpose of the group. We require that anything being sold here have a price

Does anyone have a list of the ID returned by CAT control for the following ID's which are missing? suspect TS50, 140, 690 etc. are in there? * 1 * 2 * 3 * 4 - TS440 * 5 * 6 * 7 * 8 - TS950 * 9 *

Broken slugs and twisted off forms. You know the fool had to be using a steel screw driver or allen wrench, frequently the wrong size. That was bad enough when we could still buy new parts from the

Bob . . . And the effects of the "golden screwdriver" where tweaking was done to "improve" the signal (both TX and RX). Donald KX8K ---------------------------------------------------- Some

Back in the early '70s I discovered that CB repair was not a money maker for me. Had the second phone license for transmitter work but almost everyone wanted me to "tune" up their CB to make more

Mark, I'm going to lock this thread since what you're asking here is illegal. The radio will put out a lot more power than allowed and it is not FCC type accepted for use on the 11 meter citizen's

Hello, which 10 meter crystal do I remove to install a 35.895 MHz crystal for 11 meter mod. Thank you in advance, Mark

Hello group, which crystal do I remove to install a 35.895MHz crystal for 11 meter? First time doing this to a TS-520S radio. I was told lowest 10 meter crystal, is this correct? Thank you, Mark

Power Supply, Microphone, Filter, Mobile Bracket, Linear Amp T/R cables, Crystals and more For Sale: . Kenwood PS-430 Power Supply: The Kenwood PS-430 power supply provides 13.8 VDC at 20 Amps

Filter, Linear Amp T/R cables, Crystals and more For Sale: . InRad CW Filter for Kenwood: This CW filter is 400 Hz wide, striking a good middle ground between 500 or 600 Hz filters, and 250 Hz

Do research before using a non-exact replacement relay for the RF circuit. You need to verify that the replacement relay and - if added - additional wiring will not affect your SWR. Some repair shops

I installed the relay from “101automation” and it works fine. ?It is identical to the original relay. On eBay search for “ Panasonic Relay NR-HD-12V”.