开云体育

It sounds like you're about to get in way over your head. Gary

HI folks: I have a kenwood ts-520s that I am interested in possibly tapping the IF off of to hook to a SDR dongle to make a pan-adapter -- what Im curious to know - is how hard of a project would

Just take note of the sheen of the finish, too, not just the color. Is it shiny, flat, matte, etc.? You will either want that type of finish in the paint you buy or you will want a clearcoat that

Tnx, Gary. ?I have had that suggested to me. ?That may be the only thing one can do. ?I have hopes that maybe someone has found a stock spray paint color they considered a close match. ?Thank you

Take the radio to Lowe's or Home Depot's paint department. They can read the color of the radio's cabinet with their computer that copies paint colors. They will mix a can for you, with the matching

Hello. ?I am new to this group. ?I’ve been a ham since high school in 1969, and “tinker” with old radios, trying to bring them back to life. ?I am wondering if anyone has had success in

Hi Bob, If I remember correctly, the problem on the original boards was one or two of the SMD transistors. I’d have to go digging to be certain, though. I seem to remember repairing one of the

Just a thought, check those electrolytics near that IC. Bob W4JFA yahoo.com@groups.io> wrote:

Thanks for the suggestion and the link Eric.? I will look into that one as well, 73.. Gord. VE5UJ

It appears that Mouser has plenty of the LT1054 chips in stock 73….Eric VK2VE. Sent: Sunday, April 7, 2024 4:22 PM To: 'Kenwood-Amateur-Radio@groups.io'

Hi Gordon, Not sure if this helps but I had what I think is probably the same or very similar bard some years ago in TR751A and TR851A transceivers. This article may help

Some where on my internet travels I have seen information on replacing components of that DC to DC supply.?? The replacement cobbled up for the TS-850 has been very successful for me at least and

Hello, I recently purchased a TS-2000X with a known defective serial port. I replaced the failed serial port driver chip and was able to communicate with the radio and update the firmware. A few

Hi all, I have recently bought a TS-770 that appears to have a duff PLL chip. The chip is the SM6422A and is mounted on the X50-1530-00 PLL(A) board. I hear that these chips are quite hard to find,

You can contact?JA6QXW DESIGNER of the TS570 series.? As far I know 50W models have actually 100W PA module, just need to be unlocked.

Dave . . . Hopefully someone here has a way to get that radio to put out 100 watts. However, based on recent Icom radios purchased from the Japanese market at a lower price, then brought to the USA

I have acquired a pristine, working TS-570S from Japan and see it has the power limit set to 50W. Does the service menu item 18 allow this to be set at the standard, 100W limit for USA? Thanks

That I haven't seen. I'll have to check on that. The way it's mounted there could be something putting some pressure on it...

I've been having problems with that too. I used to be able to program it years ago with an old XP laptop that I still have, but it doesn't seem to work anymore. I'm thinking something went bad there

I looked at the manual. On the back there's a reset button/switch. Maybe that's defective? Shot in the dark. Bob W4JFA