开云体育

David, A good friend had the 850 and sold it to me when the 870 came out. I've had it ever since. I love the 850. I do have the digital recording unit in it which I had recently replaced the back up

Thanks Tom. I just verified that the Band scope function is working as well. I am enjoying dimming the lights and tuning around the band as well as using the other SM-230 functions. It makes a nice

I've made a few "discoveries" about the root of the BCB problems I have been having. Should I post my findings here or on the 850S page...? 73...Jordan VE6ZT

David- Sorry- I misread your post title.? My monitor is a 220. You have the spiffy updated 230! My comment on the caps may not apply to your new-fangled? model.? I apologize for any confusion I may

David, Very nice! I had one years ago and wish I had another. It was nice with my 850. Maybe some day I'll have another. Bob W4JFA gmail.com@groups.io> wrote:

I have tested the SM-230 and it seems to be working just fine. Below are screen captures on the two tone generator input to the oscilloscope function. First is the 1000 hz tone, then the 1575 hz tone

Hi, David, Congrats on a very useful acquisition!? I went thru this same exercise last year- my unit worked as soon as powered up, but I noted 5 gray electrolytic capacitors on the board with splits

I have unboxed the SM-230 and plugged it in. It seems to be functioning, but I just have to obtain / make up cables to connect with my TS-850s. The manual refers to the TS-950, but i assume this can

Your reason for selling, please, as well as date of manufacture? Does sub-menu 61B state "Off"?

I have for sale a Kenwood TS2000 HF/VHF/UHF all mode radio, which does 100 watts on HF, 6, and 2m, and 50 watts on 70cm. It also will do full duplex for satellite operation. Has a AM/FM subreceiver

I have a Westmountain Radio Rigblaster Plus soundcard interface to do digital modes from your computer with your rig.? Great for FT8/FT4, PSK31, and other soundcard modes.? It comes with the the

I don't think so because in the fault condition SEND and AT TUNE don't work either. -- Mike G8GYW

Well, I replaced the diodes and it didn't make any difference...Time to make some dinner...73...Jordan...

Mike, if you can't provoke the symptom by probing around the connector and it's leads, and you can't produce the problem by prodding the board itself, I'd be taking a good long look at the connector

Ooops...it should read "...which formed part of the BCB attenuator..." 73...Jordan...

Hi group.. I have a 450S which has served me very well for ~30 years now. Long ago, I jumpered the resistors which formed part of the BCB, effectively removing the attenuator. It was fine for years

Thanks Gary, I will try that next time it fails. -- Mike G8GYW

No the cable wasn't plugged into anything else. When the fault is present none of the PTT functions works (MIC, ACC2, SEND, AT TUNE). I presume it's a standard 13 pin DIN socket so the cable plug

P.S....that cable should plug in quite easily...are you sure it has the right pin spacing..?

Mike, is that cable plugged into another device..? If not, there is a PTT connection from the ACC2 connection for that cable. What happens if you ground the PTT connection...? I've never seen a