开云体育

Have you considered saving the radio's program on your computer, and then wiping the radio? Reload the program afterwards. Gary

Every so often-too often-my G707 will do a full reset on power-up. It doesn't seem to be consistent, with things like voltage not being a factor that I've seen. I see nothing that says these radios

Hi Phil, Thanks for the suggestion. I looked up TMA connectors and if what I found is correct, these are small coaxial connectors. What I am actually looking for is a two-pin inline connector.

Hi Stan, I think the connectors you may be looking for are the 'TMA' type and are available on eBay from various people. Regards Phil. GW1HNG ________________________________ Sent: 20 March 2024

Hi Donald, Thanks for the suggestion. Unfortunately, the real estate on the PC boards is too limited to mount SMA connectors directly to the boards. If I were to use SMA connectors, they would have

Stan, I know you're trying to make the radio the way it was from the factory, so this suggestion is only if you can't find the connectors you're looking for. If you don't find the connectors you're

Hello Members, I hope this is okay for me to post. I have recently designed and printed the cover pins for the kenwood hybrid radios. I am offering them on eBay. I have never found another source for

Hello Members, I hope this is okay for me to post. I have recently designed and printed the cover pins for the kenwood hybrid radios. I am offering them on eBay. I have never found another source for

I had a similar issue with my TS450SAT about six years ago.? My resolution was to remove the CAR board (under the speaker bracket), clean the CAR circuit board mounting screw ground pads (both sides)

After finding that the output from the RF board to the amplifier board was nowhere close to the proper amplitude, I focused my attention on the RF board. I checked and rechecked the board, but

Has anyone had this happen, and found the culprit? PLL board? IF board source? The known filter cap that leaks on in the audio coupling has been replaced. Thanks, and this is a great group! Dave

Just google - kenwood kpg d6 It will supply all the info you require. You can then use Google Translate to change to your language . Hope this helps you to get ahead on your problem. Bob

Okay, I thought you were needing a coaxial connector. Mike

Hi Mike, Thanks for the pointer, but the connector I need is the simple two-pin male connector in a white rectangular housing, similar to the other multi-pin inline connectors on the various boards

Can someone help me, if they have the software for the Kenwood NX-1300? Thanks in advance

Not sure, but this may be what you are looking for. They are the connectors that are used in a Kenwood TS-930. https://rfconnection.com/tmp-tmp-cables-taiko-denki-connectors/ Mike

*The Spanish To English Translation is: * *"I request support for KPG-D6 Software, could you help me??"* *Lou WA5LOUGroup Moderator* *[message Edited)* [email protected]> wrote:

*The Spanish Translation is: * *"I request support for KPG-D6 Software, could you help me??"* *Lou WA5LOU* *Group Moderator*

I believe that lezelaya99@... is asking "I usually ask for KPG-D6 Software, you can help me". Tim kc1twr -- Tim Rodgers KC1TWR TimKC1TWR@... Cell/Text: 860-460-7360 "Train as you expect

Solicito apoyo para Software KPG-D6, podrian ayudarme