开云体育

Run this command: cat /etc/ax25/axports and post the results so we can take a look at axports configured -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack ) | Tip Jar (

BAP is no longer being developed. Give 73Linux a try which can be installed on top of BAP. https://github.com/km4ack/73Linux?tab=readme-ov-file#install 73Linux is very similar to BAP but also supports

Use 73Linux instead of BAP. https://github.com/km4ack/73Linux?tab=readme-ov-file#install You'll have better luck. There are some known issues though with Wayland. Conky doesn't work. VARA won't

My problem ( /g/KM4ACK-Pi/message/12595 ) with getting the “ *Unable to establish connection with remote: No AX:25 ports configured* ” error in the Pat mailbox window in Chrome is

Yes, I'm seeing lots of packets and decoding them. The map in XASTER fills right up, the one in YAAC doesn't show any. If I look in the decode texts, it is loaded with stations, except for mine. The

Step one is rx packet with good success so you should be able to ignore PTT and it sounds like you solved PTT anyway. The radio sound should be consumed by direwolf and you should see raw packet

I tried the "PTT RIG 2? localhost:12345" and it complained with the error: "Retrying Hamlib Rig open..." So far, in direwolf.conf I have tried all of the following, or some variation: # #PTT COM1 RTS

Will build a pi work on a pi 5, as see a lot of software have issues, thanks Lee

Thank you Jason and Kelly. I followed the video and Pat Winlink started up, but I got this error “…No AX:25 ports configured”. What did I do wrong?

Kelly is spot on. This video has more detail - https://youtu.be/yp5rghcNO4Q -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack ) | Tip Jar ( https://www.paypal.me/km4ack ) Twitter (

dire wolf cant get rig control the port issue could be a problem with port 5000 and not 8080 k

the correct port is 12345 now, so the line should read.. start flrig make sure its working, and open dire wolf after PTT RIG 2 localhost:12345

I've also noticed that YACC doesn't any longer populate the map with stations heard, just my k1ypp-10. That did work, but now, does not. However, XASTIR still populates the map but has that constant

Made no difference, plus, I have to get it running before Direwolf times out. Thanks Dennis, K1ypp

I am setting up a Raspberry Pi 4 GB previously configured with Build-a-Pi for my new ICOM IC-705 using these two videos: *ICOM 705 Build a Pi Setup* https://youtu.be/JnDutR-ReR4?si=uERZVlmIutCQiMFM

Yes start flrig after start direwolf k

Thanks Kelly: I did try that and I get: Dire Wolf version 1.7 Includes optional support for:? hamlib cm108-ptt Reading config file direwolf.conf Audio device for both receive and transmit:

Jeff, I did not have the tuner attached. But also I discovered that I had menu #85 set to Tuner, if I set #85 to Off, then I'm able to change #20. Thanks for your reply, I just bought the FT857D and

If flrig works point direwolf to flrig for PTT? PTT RIG 2 localhost:4532

I've been beating my head against the wall for close to a month now trying to get ANY Direwolf and YACC or XASTIR combo to build a digipeater, Igate combo. I have an FT-817nd, RPi 3, Yaesu CAT cable