开云体育

Hi I have had a problem a few times. I may get cleared up if I reload the OS onto the mico SD drive, I use Buster yet. What happens is that when inserting my PNY 16GB drive I use to save files I

I found the script "getardoplist" in /home/pi/patmenu2. Inside it says: #Two versions of this script exist. One for manual downloads and #one for cron downloads. The one for cron has no YAD

Where should I look in the file system for the outbox location? I did find archive, in, out, sent in this path... ./home/pi/.local/share/pat/mailbox/K4GMV so I then searched the entire system to

I would say hop on Toads discord and talk to Joseph. 73 N5SKT [email protected]> wrote:

Thanks for the picture! Now this is even more intriguing. Moonbounce with that little yagi? and low power.I have got to learn more. Jim

In Jason's previous message, we reset the config file to defaults, then updated the call sign, password and grid square, so I don't think it's a problem with the config file. Hope everything is ok

I'm glad I could fix your Telnet issue! Not sure about your other one. I'm on the way to the hospital again now and I think Jason is going to be out of commission for a few days so it might be a bit

Rich/Jason, tnx for guidance. I made the changes in Jason's video but somehow I must have been fiddling and the entries were all changed. I made video changes and all is well again. -- Tom

I have my grid square defined in the config.json file. I've updated it manually and by GPS in Pat Menu. Conky is showing my grid square and the "Find Gateways" script sees my grid square,. But when

Oh, Joseph built the Yagi shown and I think that is an Icom 7100. Best Regards, Don -- Best Regards, Don - N5SKT

[image: image.png] To be clear, this is Joseph's success. Joseph's call is VE3GKT. 73 de N5SKT [email protected]> wrote: -- Best Regards, Don - N5SKT

Tell us more! What is your system? Antenna and software? Someday I would like to have success with my 9700 but not able to decode anything yet.Jim KI6WJ I

[image: image.png] -- Best Regards, Don - N5SKT

Yikes!!! You know Jason's recent video about spending hours going round-and-round in circles, looking for something complicated, while ignoring the simple mistake? Yep... I was selecting telnet under

The very tip drop down where it says select alias. As I recall you have to select telnet there and it will fill everything else out. From your picture, it looks like you did not do that.

I did the above and edited the config file (using pat configure) to update my call sign, Winlink password, grid square and change the port. I restarted pat (sudo systemctl restart pat@pi ) againso

How do I get Winlink to automatically transmit my location to APRS.fi? I want the node name, in this case Kb5wck-2 to show. It did it the 10th but hasn’t since. It had the wrong location and now has

I have a good head-scratcher here. Here is what I'm working with: Raspberry Pi 3B+ OS Buster Kernel version: 5.10 FLDIGI 4.1.20 FLAMP 2.2.06 I can't get FLAMP to decode at all. I have very strong

Good catch on groups.io protecting the email.? I was wrong in the post on the Pat Forum. This isn't a Pat Menu issue but is something between the pat config file and the browser. We took Pat Menu out

Wayne, Basically, I followed configuration guidance from OH8STN's youtube video Xiegu G90 Digital Modes Setup - YouTube ( https://www.youtube.com/watch?v=xRcHVFRUL4U ) Xiegu G90 Digital Modes Setup -