开云体育

No headache at all. Check out the FAQ page for the solution - https://app.simplenote.com/publish/wY3zjT -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack ) | Tip Jar ( https://www.paypal.me/km4ack

I agree with Brian. I had that same issue with my 891 initially. RFI.

I've found the G90 Cat control to be much more sensitive to stray RF than the 891...even if your cables are ferrited. Try transmitting in a dummy load..if no issues, stray RF (common mode current) is

I have been running my FT891 via the FLRIG software successfully and WSJT-x for FT8 works well.? The sound card is a MiniProSC and that works 4.0!? Now the problem is when I replaced the FT with my

Could be worth looking at the interface you are using.? I was shocked to find that the Digimode-4 was likely the cause of the intermittent failures to connect.? It's a generally well-regarded

Been using it for while and after the patch been on fritz. ALC levels all over the place and the Vol levels keep changing. I went from PI4 2gb to 4gb and went back to the 2gb have issues. Had re-flash

Hi Jason, When I try and go to BAP Update tool it gives me a error that states “failed to execute child process “xterm” (No such file or directory ) I can choose other categories just not the

I believe the port (5000 or 8080) is just for the web page portion of PAT Menu. Going to the IP address 127.0.0.1 means "this computer", Adding the :8080 or :5000? to the end of the IP address just

Bob look at your menu bar upper right corner you will see an icon that has vnc. that lets you know if vnc server is running. if not go into Raspberry pi configuration interfaces select 3rd down vnc

Yesterday, I tried using the USB cable that comes with the Xiegu G90 and is used for updating firmware (the one with the blue USB plug).? I was able to connect to flrig using that and CAT control

Yes -- Loyd C. Headrick WX4LH <http://wx4lh.com>

Thanks, Julian. I appreciate the details.. double checked everything and it all looks well. There were only two things that were different in my settings. One was that you have port set to 5000, I

Ken, I'll be listening for you on the airwaves from Aid 07 (Twin Creek) tomorrow! I didn't realize you traveled here from California to help out. That's amazing! Wishing you good luck tomorrow. Looks

I did understand that. The problem was an authentication problem. I went in and changed my password on the pi and that did the trick. I’m in! WooHoo ? Thanks for your help. Now, back to the

I gave up on the Xggcomm interface. The Digirig interface worked like a charm, on my Pi plus my Toughbook. 73 *Don PoapsNew Westminster, BC*VA7DGP DATA VA7QU VOICE *Winlink: va7qu@...

Anthony, I keep a detailed record of everything I do when I install stuff on my Pi so that I can replicate it later. I have Winlink and ARDOP working just fine on my IC-7300. Unfortunately, my IC-7300

Peter, What cables did you need for that setup? David

Jason / Anthony - I’m currently in Logan, UT getting ready to work Bear 100 this coming weekend as a radio volunteer / WInlink operator (one of my favorite activities with ham radio). I’ll be back

Hi, Jason. Yes, he sent it to me prior to posting it and everything was set up correctly. I’m at a loss. I will table this until you have time to look into it further. Thanks for the reply.

did you double check your digital setting for the G90.... The first time i used mine.... I struggled... this helped my to be certain about the settings it requires.