开云体育

Run this command: *arecord -l* and it should return something like this **** List of CAPTURE Hardware Devices **** card 2: CODEC [USB Audio CODEC], device 0: USB Audio [USB Audio] Subdevices: 0/1

I did not mean to add that #antenna and I can't see a way to delete it. Perhaps a Mod can pull that off.

Good information and I’ll be checking my setup. Thanks

#direwolf I'm new to Pi and Linux and working on my first Build a Pi. I followed Jason's APRS video and everything seams installed correctly but I'm getting a Dire Wolf failure and it shuts down

Over 8 hrs into this now, still blank screen. I would like to get this running before we head to Alaska on Wednesday, simply for FT8 (WSJT-X). Should I just omit the other packages and try another

After a few minutes involving some transmitting on just sitting there receiving? If transmitting, more than likely you have an RF common mode current problem. Do you have a dummy load. If so, try

I have FLrig running and setup with my FT891.? After getting the MiniProSC sorted out and working well with my FT891 and G90 I have run into another problem.? When I get FLRig running with my 891 it

I am doing my first-ever venture into the Pi world. I am running BAP on a Pi 3B that I had, with a fresh latest OS, and seeing the stall at the below-mentioned fldigi-confdialog.o line in the script.

There is probably a better way, and most probably don't need/want it, but I figured I would share. Today I decided to setup Conky for myself, using the directions from KM4ACK's video on adding the

Just wanted to let anyone know I got it working. My stupidity I discovered the connect command is :connect callsign not just connect callsign.? the : is required

Clean install, exact same results. It is a newer signalink, not that should make a difference. pi@hampi:~ $ lsusb Bus 002 Device 002: ID 174c:1156 ASMedia Technology Inc. Bus 002 Device 001: ID

Your response, as usual, was right on, Jason. I haven't completely solved my flrig problem yet but I discovered that I was using the wrong connection between Signalink and the TS-2000. I switched from

Hello folks Our club has had some recent interest in doing standard packet (not aprs). So I am trying to setup my pi to run as a packet terminal I have direwolf setup to use my IC 9700 and have tested

The images is before I added the DB9 connector etc, but this give you a general Idea The box is now quite overcrowded and attaching the connectors is quite an headacke. Hope I do not have to do this

-- 73 de Eugene / ZR4EM

-- 73 de Eugene / ZR4EM

Ok, I am watching your video on BAP Updater that you just released, and decided I will try another clean install. As the only thing I have setup at all is APRS (Xastir, Direwolf) anyways. So not hard

Well I first put this question in the yaac group, there they told me, to raise it in the direwolf group, so not really helpful ;-) Klaus Von meinem iPhone gesendet

Pulseaudio mixer doesn't work either. It is the latest raspberry pi os on a pi4 4gb with all options selected using the build-a-pi script. It just happened I names the pi happiness.

I have never seen this before. Do you have controls using the GUI? Try right clicking on the speaker icon in the top right corner of the desktop. Are you running Build a Pi or hampi? I ask because