开云体育

Ok , I’ll give that a shot …. Again last time it caused me a ton of issues but flrig does talk to the dx10

I personally wouldn't mess around with Hamlib too much and just set it to use rigid #4 (FLrig) and use FLRig for rig control. It's so much better, more capable, and easier to use when you have

Well after manually installing Hamlin-4.6 rigctl now reads the ftdx-10 but now I have this issue ( see picture)

PRELIMINARY…..I think I fixed it , had to uninstall Hamlin and manually install hamlib4.6 ./configure —prefix=/usr/local —enable-static make sudo make install sudo idconfig reboot

Well, slowly I’m learning some of this Linux stuff ! HI I have a couple SD cards that I go back and forth with. What I decided to do was manually install Box86 and Wine thanks to a great how-to

I have/had conky running but the config file disappeared on me or it’s now a generic one , but anyway I’m about to give up…..lol

I'm having about the same, but I haven't even noticed it go green. I'm on a fresh Mint/Linux 73 install with G90 via Digirig.

Having an issue with pat and rigctld says connection refused and I am LOST. rigctl turns green in only then goes out , on my phone atm will try to login on the pi and website Thanks N5ATK

Is there a time limit to install something on a RPi or something ? I’ve been trying to install VARA (using the Pi-Apps install) and I’ve noticed that it will go so far in the installation and just

At the time, it seemed to be one and the same problem. But maybe not. 73, Jamie WB4YDL

I did a bit more digging into this. I cannot reproduce the "permission denied" when running the sudo rfcomm command. I tried with both the 32 bit and 64 bit versions of Pi OS and it worked with both

Well, I actually got Jason involved on this and it stumped him. He tells me that Bookworm isn’t “ready for prime time”. After many hours messin’ around with it and getting nowhere fast, I

Well, I’m back at it after the holidays. I did manage to get the RTC running correctly thanks to Jason’s great help and article. Getting the Mobilinkd TNC3 to work is a different matter and I just

Hello!? Installed 73Linux on fresh baked pi 4B running "bookworm."? Some minor issues: *Grid square not displayed* on pat menu even though correctly entered in config file. This causes an error-msg

tried making changes to ardopcf with no change.

What I found, I recently did the 73 Linux update. That is when the problem started. After attaching a dummy load to troubleshoot, I noticed that the output of my radio reset to high (100%). I normally

What Kevin said.? Depending on how Direwolf is configured, digipeating and beacons may be supressed until there's a GPS position lock.? Clear view of sky helps immensely (my basement window might

RFI or common mode current. Confirm by using a dummy load. If problem disappears, it's confirmed and should be addressed. wrote:

When working FT8, the frequency readout in WSJT-X will jump all over the place while transmitting. The radio is unaffected and remains on frequency and FLDigi is usually unaffected. However on

One thing to remember is that some items with the GPS won't start working until your GPS can contact satellites. Try moving the system to someplace that has a clear view of the sky. Good luck. Kevin,