开云体育

I reinstalled BAP from scratch on a new copy of Raspberry Pi OS, and it worked.? I suspect that something either changed or was not installed properly to begin with.? My suggestion is that if you

Jason, Thank you for all the hard work! ?This makes setting up a Pi for Ham Radio so much simpler. 73 KE9A

Jay, I’m using the HiFiBerry case and there’s room for the DockerPi power board and the RTC clock on the GPIO. I think it’s a pretty nice case for the price. 73 de AG7TX David Thompson, AG7TX

Jason, Does the case you list work with the DockerPi and the RTC? Combined, they’re too tall for my current case and the only extra tall case I’ve found is $50! I’d rather wrap the whole works

Morning Jason, Thanks for the note. I had watched your video and that is what inspired the testing. I already had the GPS receiver in-house and was wondering whether use of a USB3 port with a USB2

The GPIO on the Rpi4 is the same as that of the RPi3. I use the same RTC's on both boards. -- 73 de N5RKE

I was in the marine electronics business at the arrival of consumer GPS. I don’t recall anything getting a fix from a cold start in a new location so fast.

Jason, I was recently able to purchase three IC-718 rigs for a reasonable price. That gives me four sitting as back up. I have the cables so one can be hooked to the Build A Pi (and it works). I am

The stable version (3.0.3) of build a pi is out. Provided you are running 3.0.2, upgrading should be as easy as running build a pi from the main menu. This version add compatibility for more GPS units

It is the USB 3 port that is giving you the issue. I discovered this during this past field day. I have tested with multiple USB 3 thumb drives/adapters and all have produced the same results. I go

Mike, Here's a list of accessories including the RTC that I have tested. https://app.simplenote.com/publish/4W4h4y -- 73, de KM4ACK YouTube ( https://youtube.com/km4ack ) | Tip Jar (

Don, That’s an interesting unit. I might have to check one of those out. David Thompson, AG7TX Jack of All Trades Master of None dbthompson@...

FWIW, I just hooked up one of these for the first time. Amazingly fast fix. BN-80U Dual USB GPS GLONASS GNSS Receiver with USB Level 5.0V Supply Voltage 2M Length for Laptop PC Car Marine Navigation

Hi Don, I just set up my home Winlink station to use UZ7HO Soundmodem with a SignaLink running Winlink Express; and also my RMS Packet Gateway with UZ7HO Soundmodem and the RMS Packet software.

Mike, This is unit I'm using. It plugs right in and works just fine. https://amzn.to/313TPBF Best...

I understand Mark, My current objective is to determine whether I can operate this unit in the field with a short cable (of course). I'd prefer to mount the GPS receiver to the top of the Pi so keep

Thanks Bryan, I'm using a short cable because I want to know if I can operate the Pi4 in the field, which will require a short cable. For home use I don't care how long the cable has to be and will

If you are using the little dongle GPS, then an extension cable will probably help.? The GPS antenna must have a clear view of the sky to have a reasonable signal strength.? In addition, the farther

Well, I’m out in the boondocks and I fired it up. Saw and connected to it. Rebooted and never saw it a again. When I return to broadband, I make a new build and install just HotSpot tools first,

More investigation... I have a Pi 4 also with BAP and when I ran Hotspot Tools on it, it showed an SSID and Password, and it works just fine. I poked around a bit, and found /etc/hostapd/hostapd.conf