Re: Xastir SignaLink Direwolf
|
Jess
Have you turned off your TNC??APRS12, Packet12, and just run the signalink through the data plug on the body?
73
Don
Don Poaps
New Westminster, BC
VA7DGP DATA VA7QU ? VOICE Winlink: va7qu@...
Subject://wl2k ? ? ? ? ? ALLSTAR ?530780 HH# 5971 HH# 11384 Alberta Mesh# 5404
? ? ? ? ? ? ? ? ? ?
On Wed, Sep 1, 2021 at 2:50 PM Jeff < KO4NCC@...> wrote: I apologize if I'm just not getting it and I've searched and searched and watched a few videos and get stuck at the same place.
I have BAP 3.0.8
SignaLink connected
GPS Connected
When I start direwolf here's my results:
**
Dire Wolf version 1.6
Includes optional support for:? hamlib cm108-ptt
Reading config file direwolf.conf
Audio device for both receive and transmit: plughw:2,0? (channel 0)
Channel 0: 1200 baud, AFSK 1200 & 2200 Hz, E+, 44100 sample rate / 3.
Note: PTT not configured for channel 0. (Ignore this if using VOX.)
Ready to accept AGW client application 0 on port 8000 ...
Ready to accept KISS TCP client application 0 on port 8001 ...
****
In all your videos you get the device name of the KISS TNC for entry in the Xastir Interface Control dialog box.
So I end up stuck here and can't proceed.
73 de Jeff KO4NCC
|
Don Poaps