Thanks Dominic ! I¡¯ll try that. In reading more, looks like I need to add an ¡°overlay¡± for the device.
73, Jamie
WB4YDL
toggle quoted message
Show quoted text
On Dec 16, 2024, at 1:50?AM, Dominic OE7DRT via groups.io <tidy.wing5149@...> wrote:
?I usually do that with `sudo`, like my usual routine for that is:
#v+
$ hcitool scan
$ sudo rfcomm bind 0 {MAC_ADDRESS}
...
$ sudo rfcomm release 0
#v-
Using `rfcomm connect...` is practically the same, but you may need to
leave the terminal window open and quit with `CTRL+C` when you're done
with the connection.
hope that helps,
-dominic, oe7drt
James C. Hall, MD WB4YDL <heartdoc@...> wrote:
OK, next issue ¡
First off, I reviewed Jason¡¯s YT video on the TNC3 and the updated PAT
Menu - about 2 years old - and the older (pre-PAT Menu) video using a
TNC2 - about 5 years old.
Going to PAT Menu -> start/stop modem -> Start Mobilinkd Modem BT. Get
connection successful. Clicking Start Mobilinkd Modem BT again (as
required) does NOT give a connect and HTTP. It restarts the first
dialog - endless loop..
I tried to do the older method with copying the MAC address with
hcitool scan and then running rfcomm connect an I got a permission
denied for connect.
I tried going wired to the TNC3 and it worked flawlessly.
Any help appreciated. Going to stop here for the day - not tackling
VARA until later !
73, Jamie WB4YDL
--
The intelligence consists not only in the knowledge
but also in the skill to apply the knowledge into practice.
- Aristotle
