Another option for composite brads is:
A bit expensive but working ok. I used it to hold the 8mm panels on the duo1000. Works on a compressor.?
toggle quoted message
Show quoted text
Op 17 jun. 2022, om 00:20 heeft Rod McLaren <
nkosuohene@...> het volgende geschreven:
Here is an early review of the Rapter stapler and the composite staples offered by Duckworks. The stapler just arrived after a brief backorder wait and I was interested to see how it operates. This is a very quick and really quite preliminary review. I will try to add to it after I have made use of it in my ECO 6 build which I have just begun.
Three staple lengths are offered: 1/4 inch, 3/8 inch and 9/16 inch. I will use the stapler primarily to hold 6 mm panels to Douglas Fir stringers and so I ordered 9/16 inch staples. This required turning the tension on the stapler to its higher setting and even with thats the staples are not set flush. However, it looks like it will hold the panels tight enough for the epoxy to set. The crown is easily knocked off and sanding leaves the surface flush.
<IMG_6594.HEIC><IMG_6599.HEIC><IMG_6600.HEIC><IMG_6601.HEIC><IMG_6602.HEIC>
