开云体育

Thanks, Mike. Al and I are so busy with another project, I haven't gotten around to a rewrite of the manual. Jack, W8TEE

Excellent. I was just getting ready to post. After several months of not getting much bench time, I'm back in the saddle. I need the latest versions of the assembly manual. Thanks, Mike.

I put a new file on the group. I took the latest versions of parts 1 & 2, combined them and added bookmarks and a table of contents with links. Mike AI4NS

All: Al and I will be attending Field Day and will be at the Milford Amateur Radio Club (MARC, W8MRC) at Paxton-Ramsey Park just outside the 275 loop, close to Wards Corner exit. We will be using Al's

Thanks Jack, John (G8STW)

My S meter was acting more like a VU meter and would always return or start at 0 even in high noise area bands and would only react to modulation. I found that by changing a value in the SMeter.cpp

Hi Rick: First, nice implementation...looks good! Actually, I thought I had that sideband issue anticipated because of the popularity of the digital modes (FT8). I'll check into that and post the fix

Hi Jack, I have the JackAl board installed and working quite well except for the hickups in some areas of the software.? I have been reviewing the code but can not figure out if there is a simple way

I did not say that mods are "needed", only answering a question that was asked. The "protection mod" is addressed on the JackAl groups' site. I'm sure it's possible to connect a power source

OK nothing yet. BTW I just saw a message from Jack, W8TEE about needed mods to the current production of these boards. Does you instructions includce all of those mods? 73 jerry NY2KW Sent:

The board has not been changed, so you should add this on. We will need to work off our inventory before we can add the change. Jack, W8TEE

I have just ordered my board and wondered, are the display protection mods now incorporated in the main PCB or do I have to build this as a separate item / is a additional board supplied? John

Another reminder to let me know off reflector when you received your stuff. thanks n2aie vince

I prefer the 5" as it is large enough to use, but keeps the case size down a bit which may be important for portable operation. Also, the smaller screen does draw a little less power and is less

Any thoughts on whether the 5" or 7" screen size is better? I would prefer the smaller size I think as there ar more case options but any thoughts from those who have tried either or both?? Much

https://en.wikipedia.org/wiki/C-4_(explosive) -- “si vis pacem, para bellum”

I received a board from Vince and have a question about C4. The PCB silkscreen looks like it should be a polarized cap but the picture Vince sent with the board has a ceramic cap at C4. The schematic

Steve, I was out of pins...I'll have to send those to you for the connectors (requires 2x5 x 2) but i sent out the rest of the kit. V [email protected]> wrote:

Done Vince..thanks Steve Behlmer

Steve, the parts will be 10.00 + 1.75 for the paypal and mail ( i found out that mailing the assembled kit was over a dollar more than i was charging..) parts are small and flat minus the