开云体育

One of the values in the loop I had you add placed the display in the orientation you wanted. Take whatever that value is and ?? tft.setRotation( (uint8_t) i);? place it where i is above. Erase all

now that there is a way to rotate the image on the display what must i do to make this a permanent thing?? i am not a hacker so do not know what to do with this information. dave? k7da

It could be done, but we're investigating other alternatives. Jack, W8TEE

Hello Is it possible or planned to operate jackai in Sdr mode with a rtl Stick ?

Then it's working? If so...good on ya!!! Jack, W8TEE

YES

Those two files are attached. Jack, W8TEE

Are you saying to see the main display page that looks like this: Jack, W8TEE

it did compile and and it id upload? the code works and now how do i use that info to effect the display permanently? and i assume remove the provided code.? i did not have the serial link hooked up

Jack, any chance of getting the EEPROMNew.cpp and DisplayCalibration.cpp ?? if that's all i need? I'm kinda stuck Vince n2aie at arrl dot net

Totally agree! (Though I wish I'd seen your new illustrated step by step for the audio cable before i made mine.)73'sRon W0QVJ?Sent from my Galaxy Tab? E

also agree nice job. vince n2aie

thanks cause we are on hold for the build vince

Jack & Al, thanks for all your hard work in developing the JackAl board and the revised wiring harness directions are just great! Appreciate all that you do.? Regards, Guy WB7SZI

We'll take a look into redoing this, too. Jack, W8TEE

Jack, Looks like this is also a bit of user doc that needs additional detail. Dave is making up cables and found that it isn't clear, or he hasn't found detail drawing/ schematic of those cables?

had a problem with the audio that i have been trying to find and it turns out to be the headphones i was using. now i have to put the thing back together before i can upload the code. try again

If it compiled and uploaded and ran, that's what's important. What happened on screen? Did it say Upload Complete? Jack, W8TEE

it complies now but there are some warnings that i can figure out how to copy. dave k7da

oops close but no cigar dave