开云体育

I said go INTO the setup() function and place the code. You didn't. It should be: void setup() { // a bunch of statements.... // At the very bottom of setup, BUT INSIDE IT ? for (int i = 0; i < 4;

i got an error as follows Arduino: 1.8.8 (Windows 10), TD: 1.45, Board: "Teensy 3.6, Serial, 180 MHz, Faster, US English" JackAlV095: In function 'int SetFilterCenterFrequency(int, int, int)':

All: Several of you have written me saying that you were having difficulty making the wiring harness for the JackAl system because the directions weren't clear. (I believe the word "sucks" was used

The change will be a separate file and I will be making an announcement within the hour... Jack, W8TEE

Selling the 7 inch display $35 + 2 for shipping. will trade for 5 inch. Vince n2aie

Hey Jack, Looked at your site, but didn't yet find your new v5 updates. Now that my v5 board is here, ( and the new teensey), is it going to be available soon? Anything I can do to help? 73's Ron

I assume that you have a graphics object named tft. Go into the setup() function and add this code at the bottom: for (int i = 0; i < 4; i++) {?? tft.setRotation( (uint8_t) i);?? tft.setCursor(10,

i mounted the display upside down and turning it over makes it not fit the hole. so i need to turn the picture upside down. is that possible in sofeward or alectrically? dave k7da

What do you mean "turned over"? There's a Landscape and Portrait mode Jack, W8TEE

can the display be turned over in software? dave k7da

can the display be turned over electrically? apparently the display is not symmetrical about the mounting holes. dave k7da

Thanks, I appreciate it.. actually a copy of the .ccp file that i can drop in would work too.. Vince n2aie

A guy here in town has our 7" display and he's back from CA. We'll see what we can find out. Jack, W8TEE

Another alternative is a bezel to fit over the opening. Al and I have gone with printing a cover on photo paper and carefully cutting the opening with an Xacto knife: We think it came out pretty well.

the hole for the display would be best done by someone with a mill.? talk around to friends and try to find someone with a mill that does hobby work and have them do it for a few bucks.? much better

Finished the 1st one and It's ok, but I'm pretty sure it can be done a lot better. Some mistakes: Ordered my box before I sized the display, so limited myself to a 5" display Built my power supply

so at some point i got it calibrated, and squirted it.? Still not calibrated. ugg no real success. Vince n2aie

Thanks Jack. Appreciate the reply? 73, Guy WB7SZI

Thanks QRPGuys My package from QRPGuys is on its way, :)) 73

Help Looking for some information on if the two wires are combined on the Clock and Control Cable.? Are there drawings for these cables? Thank you for the help! Dave G.