开云体育

Are the JackAl docs different than the BuyDisplay docs? Try to get a close up of the connector edge and post that. Jack, W8TEE

Must be me...Purchased the 7 inch display and connections on in manual 2 do not match..could someone annotate the connections to *this* board? please. Thanks Vince N2AIE

I think that I will just wait until Jack and Al have updated their documentation and Jack has finished examining his V5 board.? All may be revealed. 73 All Kevin VK3DAP / ZL2DAP -- 73 Kevin VK3DAP /

The coils are pulled and replaced by 680 nH SMD inductors: http://www.ubitx.net/2018/10/10/rajs-second-spurs-mod-simpler-again/ I have parts coming in Friday (I hope). - John

what are these two l's changed to? dave k7da

After looking at the spec sheet, they, (5003), appears to be a suitable, (maybe superior?). replacement for the 5403 which is a 400 mw coil, not as I said before 200.Little bit higher coil resistance,

Hope not too much, as I guess that's what I'm getting...;}Difference is in the coil sensitivity 150 mw instead of 200.(Going to need to start using my glasses when ordering parts!)Thanks again,

I saw an ad by them for $8.60/4, but that was for the Axiom V23105-A5003-A201, not the Axiom V23105-A5403-A201. Does it make a difference?? Jack, W8TEE

FYI, ebay, (chipsgate,was the seller), charged $8.50 for 4, and they shipped today.Ron W0QVJSent from my Galaxy Tab? E

Arrow Electronics carries them at $2.20, 10 for $2.10, or 35 at $1.96. Everyone probably knows they don't charge for shipping, so order a bunch and sell them to club members. Jack, W8TEE

Just ordered from eBay, recommended relay part no.;Axiom V23105-A5403-A20173'sRon W0QVJSent from my Galaxy Tab? E

Thanks Jack

I've slept since the post that detailed the relays, but I think I recall they are made for RF work by Axiom. You can search the BITX20 Forum for the correct part number. Jack, W8TEE

What are recommended relays (model and source)? Pete WK8S pmeier at me.com

If you're running the V4 or earlier board, it would appear that the relay changes will do the most good. The V4 units we have test okay for all bands but 15-10M, which we do use, so we haven't messed

Of the recommended mods to the stock uBitx, which are still recommended when using the JackAl board? I'll be changing L5 & L7 and probably the relays too. John W1JDS

I now think that if there is any likelihood of wanting to access other pins on the Teensy, we should probably follow the instructions of James Zdunic , KM4TXR,

Hi, Did everybody connect through the single pin marked VUSB from the Jackal board to the Teensy? Keith M6OLP

Yes it was one and the same.. Kevin, you outlined the procedure as you saw it and needed confirmation of that.. I sort of need a dummies guide myself lol

Is not my original query regharding the procedure for attaching the audio board to the Teensy and then to thge JackAl board rendered obsolete by James Zdunic's CPU-Pins_2.pdf posting? 73, Kevin VK3DAP