开云体育

I think that comes with it. You should be fine with whatever is shipped with the kit. Jack, W8TEE

Jack, Thanks! Bought one. There is an optional anvil for a idc dip type socket. Any reason to add that to the shopping list? Mark

Yep, it's time for us to just take it down. Jack, W8TEE

Jack, Your site seems to be redirecting again, puts up the "click allow", then before the allow dialog comes up, I get shoved off to hajoopteq.com. Someone doesn't like us? ;) Ron W0QVJ

Try eBay 273824408603. Jack, W8TEE

Jack, Can you convince Al to share a pointer to that Crimping tool . :-) ? I think I am using a tool like yours and not getting the knack of it. 73 Mark AJ6CU

From my experience a crimping tool helps significantly toward making a good crimp. That said, the crimp sometimes needs a tweak after removing it from the crimper. The end portion of the pin where the

All: I screwed up the eBay number for the buck converter, which is fixed in the attached doc file. Note that there are cheaper converters on eBay, but I would discouraged you from selecting one that

JackAl works with either board, but there are some improvements in the V5 board. Given a choice, I'd go with V5. As to the crimp connectors, Al has a crimping tool which, of course, works flawlessly.

Jack, My comment was probably more related to those d**n crimp connectors than anything else. Spent a couple hours in February, and couldn't get the hang of it. Will take a deep breath and take

The first harness does have new documentation which should make it pretty easy to build. I've been really busy the last two weeks and have not had time to update the other harness. I will get to that

Just wondering whether there is any advantage starting with a v4 or v5?? I have a V4 working. Have not done any of the major upgrades to the v4 (harmonics/spurs, AGC, output balance, etc). Is that a

All: A number of you wanted a BOM for the Morse Code Tutor so that you can order parts now before the schematic and source code are available. This gives you an idea of the parts in the project: The

All: This document shows the way I install new libraries. It does not work the way the Library Manager works within the IDE. I do it this way so each set of libraries is "tied" to the current release

Hello, This email message is a notification to let you know that a file has been uploaded to the Files area of the [email protected] group. *File:* InstallingTheArduinoIDE.doc *Uploaded By:* jjpurdum

Robert, Did not look at parts list yet. But is this link at bang good or a part that is needed? 73 Mark AJ6CU

Hi Scott Yes since I got the gerbers from Al, I’m making 3 boards. We will figure out how to get a zener in the board. I might have to redo the board but that would be later. We have the tools to

jack in the display datasheet page 12 para 4.3 there is a? jumper config shown in the note? for the keyboard and those on my display are not set the same. should they be set per this note ? dave

Robert, what software are you using to design the panel? Bob -wb6kwt

Yes, Brian I will post the stl files here and at GitHub when the dimensional issues are resolved (TFT mounting pins need to be moved, large hole for encoder will be deleted (with and without will be