for some reason i am having trouble with the serial monitor.?
when i load the program it shows it is using port 1.? but if i
watch when connecting the usb cable it shows that i am using port
5.? but in either case i get nothing on the serial monitor.
i thought that maybe something was wrong with something in the
computer so i tried using things to load a program into a nano
card and thing worked fine. it was using port 6
anyone have an idea what is happening?
dave k7da
On 5/10/2019 6:24 AM, jjpurdum via
Groups.Io wrote:
toggle quoted message
Show quoted text
For some reason, it's beginning to sound like the EEPROM is
not getting written to. See what the EEPROM debug functions
return which I mention in another post.
Jack, W8TEE
On Thursday, May 9, 2019, 5:20:00 PM EDT, k7da
<k7da@...> wrote:
attached is a screen shot of the radio in calibration
mode.? 4 times around. ? checking again it appears
that the touch part is compressed from both sides.? if
i fiddle with it i can make most of the buttons work
with some difficulty.
dave
On
5/9/2019 1:03 PM, jjpurdum via Groups.Io wrote:
The new calibration routine requires you to press
firmly on each dot and will not let you move to the
next one until it gets a good reading. You should do
at least 3 "complete cycles around the screen"
before you exit the calibration routine. After
that's done the key values are stored in EEPROM and
used on the next reboot.
Jack, W8TEE
On Thursday, May 9, 2019, 12:59:19 PM PDT,
k7da
<k7da@...>
wrote:
should the calibration have taken that long
or longer also with each step?
dave
On
5/9/2019 12:41 PM, jjpurdum via Groups.Io
wrote:
No, it should respond in less than a
second and all of those button should be
active, so something's still amiss. What
version of the software are you running?
Jack, W8TEE
On Thursday, May 9, 2019, 3:01:45 PM
EDT, k7da
<k7da@...>
wrote:
jack or others that might
have the answers
i got the touch screen to
work( miswired) and ran the
calibration
routine but now it
appears that the calibration is not
right. have run
the calibration several
times with the same results.
the buttons do not
respond as i thought they should.? if
i press the
1800 key i get the 1500
instead.? the top line of red buttons
do not
work at all.? the other
side on the display seems to work
though.
should the response time
be 2-3 sec
thanks dave k7da
