Re: touch screen not working
|
Here's the 96 hex file: Jack, W8TEE
On Saturday, April 27, 2019, 9:09:19 AM PDT, f1apy - Jacques <f1apy@...> wrote:
Hello Jack, ? ¡¤???????? I checked wiring, ¡¤???????? upgraded my version of Arduino in 1.8.8, ¡¤???????? set up the recommended tree, ¡¤???????? the compilation works with some alarms ( pragma), ¡¤???????? I download the file Hex to teensy, ¡¤???????? it starts without problems, ¡¤???????? I use a screen 7 "it turns on correctly, ¡¤???????? I get the home page with version number 0.96, then the order page after 5 seconds. ¡¤???????? I can change the frequency with both encoders without problems. ¡¤???????? But when I want to enter the menu or change something on the screen, it does not work, I try to press (gently) on the touch screen, nothing happens .... ¡¤???????? By acquired consciousness, I tried a new screen (received yesterday from buy-Display) the problem is the same: - ((( ? From: [email protected] [mailto:[email protected]] On Behalf Of k7da
Sent: Saturday, April 27, 2019 4:10 AM To: [email protected] Subject: [JackAl] touch screen not working ? Jack checked the wiring according to what i understand the diagram says.? checks ok do you have the magic decoder ring that will tell you what each wire does?? may i be entrusted with that information. dave k7da ? On 4/22/2019 5:49 AM, jjpurdum via Groups.Io wrote: Different lines are used for the touch screen. This allows you to use the display w/wo touch. Check your wiring to the display. I'll pass this to Al to see if he has any ideas. ? Jack, W8TEE ? On Monday, April 22, 2019, 12:49:39 AM EDT, k7da <k7da@...> wrote: ? ? ? Jack ? does the touchscreen use the same data path as the viewing screen?? i ask because i get no response when trying to do the calibration routine.? is it possible to see the data somewhere in the radio? ? the calibration prints yellow lettering and a very small dot in the upper left corner but does nothing when pressing the screen for a while.? (10 seconds) ? what is necessary to get the print routine to print? ? debug was defined in the jackal.h and the serial monitor in the compiler turned on but there is no data printed.? i would think that with debug defined i should get something on the monitor as soon as the radio reboots after loading the program ? ? ? |
jjpurdum