A new version (0.96) was posted on our site (hamradiodesigns.com) some time ago and one of the things we changed was the setup for the screen. Start it up and select Setup.

Jack, W8TEE

On Sunday, April 14, 2019, 9:44:24 AM PDT, f1apy - Jacques <f1apy@...> wrote:

Hello Jack,

?

I encountered the same problem, encoder work fine on startup, but no touch screen active,

V0.95 is charged, and no error to compile. I have active debug mode but I don’t see anything.

Help will be appreciated,

73’ de Jacques – F1APY

?

?

From: [email protected] [mailto:[email protected]] On Behalf Of jjpurdum via Groups.Io
Sent: Sunday, March 3, 2019 3:41 AM
To: [email protected]
Subject: Re: [JackAl] Board powered up - Display works but touches not detected

?

Are you using the latest version of the software? Al changed the way the display calibration routine works about two weeks ago.

?

Jack, W8TEE

?

On Saturday, March 2, 2019, 9:35:07 PM EST, Benjamin Von Handorf <von.handorf@...> wrote:

?

?

I've finally completed all the cabling (except the RF to and from the uBITX) and I'm working my way through the initial checkout instructions.

I'm at the point where I've plugged in the displays and encoders and brought the JackAL board online (with lots of heat sinking on the 3.3V regulator... that one gets hot fast!) and the splash screen was a welcome sight.? My encoders are working, but I can't get the touch screen to detect anything.??

At first I thought it might be a calibration issue, but I've attempted touching all over the screen and so far haven't seen any indication that anything is being detected.

Any suggestions for debugging the touch screen?

Thanks,

-Ben