Re: 7" Display Drawing
|
Also record the values. Jack, W8TEE
On Friday, March 15, 2019, 4:54:31 PM EDT, Rick Price <rickprice48@...> wrote:
Not in debug guess I could try that. The magic number was
supposed to be at least 10 times around.? I gone as many as 15 and as
little as 6 or 7.? The average?numbers on the calibration screen are
always under 5 with a few in the 2's and occasionally 1+.? Only one of the
average?calibration numbers seems to be in the 4 or 5 region and never
seems to get lower.? I'll go and do it again and report back as to which
number stays higher than the rest. In the words of someone more knowledgeable
than me .......I have slept since the last time I did it.
?
Rick KN4AIE From: [email protected] [mailto:[email protected]] On Behalf Of jjpurdum via Groups.Io Sent: Friday, March 15, 2019 4:37 PM To: [email protected] Subject: Re: [JackAl] 7" Display Drawing How many data points (trips around the display) do you make? If you're in
the DEBUG mode, you should see the EEPROM values that are read back when the
program starts. The call is around line 955 in setup(). Are you seeing
reasonable values for all of the values shown there, including the display
offsets.
Jack, W8TEE
On Friday, March 15, 2019, 4:00:28 PM EDT, Rick Price
<rickprice48@...> wrote:
Jack,
I have the same problems on a 5" screen.? Very sluggish at times
to over responsive at others.? I have calibrated using the setup option
numerous times always the same results.? Frequency digit selection arrow
buttons are only responsive at the left hand edge and sometimes will cause the
cursor to jump 2 or 3 places.? Moving right is always harder then trying to
move the cursor?left.?When I do the selection the audio changes to a
quieter tone for the time I am pushing on the button.? I did calibrate one
time using an imaginary point to the right of the calibration points on
the?left hand side of the screen(1st two points)?and that did seem to
help center the action better. Band selection is especially troublesome when I
select 20.? 9 out of 10 times it will change to 15 and then I have to
reselect 20. I am using a fiber stylus spudger tool ?to do the selections
and have tried the end retracted end of a ball point pen and a nylon tuning wand
with the same results. Just more info FWIW.
?
Rick KN4AIE From: [email protected] [mailto:[email protected]] On Behalf Of James Zdunic Sent: Friday, March 15, 2019 2:12 PM To: [email protected] Subject: Re: [JackAl] 7" Display Drawing I¡¯m running version 95 and did go through the setup/calibration routine
contained in that version.
Jim KM4TXR
|
jjpurdum