I've finally completed all the cabling (except the RF to and from the uBITX) and I'm working my way through the initial checkout instructions.
I'm at the point where I've plugged in the displays and encoders and brought the JackAL board online (with lots of heat sinking on the 3.3V regulator... that one gets hot fast!) and the splash screen was a welcome sight.? My encoders are working, but I can't get the touch screen to detect anything.??
At first I thought it might be a calibration issue, but I've attempted touching all over the screen and so far haven't seen any indication that anything is being detected.
Any suggestions for debugging the touch screen?
Thanks,
-Ben
