开云体育

I just fixed my second power supply replacing that cap.? All the files with pictures and procedures are in the files section. Pat

Thanks to all for your help. Looked up the suggested file, and that was the problem. Replaced the cap and everything is back in operation. Mike, WA9FDO

You can try this attached PDF for starters. Ralph ku4pt

Replace the electrolytic capacitors with high current 105 degree C or better. 73 Glenn WB4UIV

There was a document floating around ...should be in the files section ...on repairing the 8924 power supply. basically a thousand screws later there is a small cap on the daughter board inside the

Rick at Amtronix (do a Google search) has helped me in the past with this issue. I highly recommend him and I am not associated with him or his busines. Just another happy customer. On Thu, Nov 17,

Greetings all, It looks like the power supply in my 8924C has died. The green light does not even come on. The fuse is ok. Any ideas? Is there anyone out there repairing them as I cannot find any info

Yes, it's so easy to forget that there is a GFI.? I had the same thing happen with mine. Apparently, the GFI may trip when the unit is first plugged in or immediately when the power switch is turned

I have had two failures of the on/off switch. It is not switching the mains voltage, but the the dc control line (similar to: standby/ON).? Unfortunately, disassembly is required to get to it.

And...I just discovered the GFI. Forgot it was there. All working fine. GeorgeC

My 8935 suddenly won't turn on. I get nothing, no fans,,,like the power cable is bad (isn't) so assuming I need to replace some caps. Looking at the -90015 manual and see its the A3 assembly, but

Brian.VK5VI I did try to reply to your email but it bounced ....looks like the server took the summer off 8)

normally I now just do the output caps as well as the one small cap in the high voltage area ( 47uf 63V IIRC )? Opinions vary of course but when you have done as many as I have you start adjusting to

Gidday All, Bill VK6II I just did My 8921A PSU and read the manual to see how to extract it. Slide off the cover to reveal the works inside, undo the nuts on the BNC connectors to the Spec An section

Hi again Mike Look at the groups file area, most of what you want is there including the 8920A CLIP. The assembly level service manual may not be, but was available on the Keysight web site, if not I

Hi Mike Yes do not try to remove the power supply without first removing the push rod, if you do you will certainly damage or destroy the push-rod, the instructions are in the service manual which is

Rick does a great job and picks up all the widely known issues. I shipped mine to him from the UK and back. His Retirement may not be so long away, don’t wait too long…. V 73, Colin G4CWH

So, my trusty 8920A decided to groan and stink now when it’s turned on versus booting into normal operating mode. Leads me to believe it’s cap replacement time and/or a few other parts. So,

Thanks to all who replied to my question. I had success setting the DAC's and running Per-Cal on my 8920A. It went from 2445 HZ off at 950MHZ to 6 HZ off. Neat capability! On Mon, Oct 10, 2022 at 9:24